SOURCE: HOW DO I REPLACE THE ALTERNATOR ON A 2006 FORD ESCAPE WITH A 3.0
disassemble the right wheel assembly and pull out the right wheel axel. Remove the alternator throught the right wheel well.
SOURCE: cruise control ford escape 2002. ford escape
If the cruise lamp comes on and the cruise does not set i would advise inspecting the cruise cable and make certain it is not broken, if ok the the servo has likely failed.
SOURCE: lack of enough camber adjustment
1. Raise vehicle on hoist, and support upper control arm. 2. Remove wheel and tire assembly. 3. Mark position of upper eccentric camber bolts. 4. Remove upper ball joint spindle nut and pinch bolt, 5. Separate lower ball joint from spindle. 6. Remove nuts and camber bolts attaching lower control arm-to-frame, 7. Remove lower control arm. 8. Place control arm in vise, press ball joint out with ball joint press.
--------After ball joint has been pressed out install new ball joint with the words "install inboard" facing toward the inboard side of control arm. Incorrect installation may cause damage to the ball joint .Install ball joint boot with words "install inboard" towards the inboard side of control arm. Install lower control arm.Align upper eccentric camber bolts with marks made during removal. To complete installation, reverse removal procedure. Tighten bolts and nuts to specification. Then check wheel alignment.
-------------
Remove the camber bolts and readjust the setting till it gets proper .
------------
Thanks. Keep updated for any more query. You can rate this
solution and show your appreciation
173 views
Usually answered in minutes!
Which one?
×