Question about 1989 Toyota Camry

Open Question

How do I override my auto watch immobiliser and 4086 it's in a Toyota Camry 1989 model for 88

Posted by Don lewis on

Ad

5 Related Answers

Jerry Parmanand

  • 449 Answers

SOURCE: steering wheel hard to turn on my 1989 toyota camry

check power steering pump fluid level and belt.

Posted on Mar 03, 2009

Ad

Anonymous

  • 69 Answers

SOURCE: removal and installation of an auto trans in 2002 toyota camry

  1. Before servicing the vehicle, refer to the Precautions section.
  2. Drain the transaxle fluid.
  3. Remove or disconnect the following:

    Negative battery cable. On vehicles equipped with an air bag, wait at least 90 seconds before proceeding Battery Air cleaner assembly Throttle cable from the throttle body Cruise control actuator cover and connector, if equipped Ground wire Starter Speed sensor connectors, direct clutch speed sensor, and the park/neutral position switch connector on the transaxle Solenoid connector on the transaxle Shift control cable Oil cooler hoses Front side transaxle mounting bolts Front engine mounting bolts Oil cooler line mounting bolts from the front frame Upper transaxle to engine mounting bolts

    0900c15280197a59.jpg enlarge_icon.gifenlarge_tooltip.gif Fig. Tie the steering rack to the engine support fixture components, as shown-Avalon and Camry
    Front exhaust pipe Engine side covers and undercovers Both halfshafts Front side engine mounting nut Rear side engine mounting bolts (remove hole plugs) Left side transaxle mounting bolts Steering gear housing Front frame assembly Rear end plate mounting bolts Torque converter cover Torque converter retaining bolts Remaining transaxle mounting bolts Transaxle

Posted on Apr 09, 2009

Ad

Anonymous

  • 209 Answers

SOURCE: Cant find Toyota Camry 1989 Station Wagon fuse box

usually fuse box is located under the dash board on the driver side.

Posted on Apr 18, 2009

localwonder

Michael Masters

  • 6784 Answers

SOURCE: reverse suddenly quit 95 toyota camry 4cyl auto

Check your transmission fluid level asap. if the level is good, you will need to inspect the shift solenoids located inside the transmission pan. replace any solenoids that are proven to be faulty. i would also advise to test the pcm/tcm for its operational value as well. this device controls the shifting patterns of the auto trans.

while checking the solenoids, if you notice any metal fragments on the bottom of the pan, this will be a sign of major gear friction. you should re build in this case.

Posted on May 24, 2009

Toyota Ed

  • 1861 Answers

SOURCE: have recently purchased a 1996 CSI Toyota Camry.

1996 Camrys do not have an immobilizer system. Whoever told you that story has no clue what they are talking about.

Posted on Sep 18, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Diagram for 1989 toyota camry serpentine belt installation


It should be on the radiator support. If not I would think any auto parts store could pull it up and print it off for you.

Jul 03, 2012 | 1989 Toyota Camry

1 Answer

Spark Plug Gap 89 Toyota Camry


I believe that the gap you need is .035 . My personal vehicle is an '88, and i set my plug gap at .035. This has worked fine for 10 years. Also, the plugs that work the best are nippondenso u-groove. My mileage and power seem to be the best with these plugs. (this is for the 2.4 litre 4 cylinder, but i believe the gap also works for the v-6.)

Dec 07, 2010 | 1989 Toyota Camry

1 Answer

We have a 1989 toyota camry the key will not turn to start the car. It has a button on top of the stering column to release the key when you turn the car off and normally when you put the key in you have...


Hi
Sounds like the ignition barrel has failed.
If you replace any part you must ensure that the key and the transducer ring are matched. If not, the immobiliser will come on and you will never start the car.
Get a diagnostic test to verify the immobiliser is turning off.
Roger

Apr 24, 2017 | 1989 Toyota Camry

1 Answer

Timing belt: need timing marks. 1989 toyota camry


For the 1989 Toyota Camry:
Unspecified 2.0L DOHC In-Line 4-Cylinder or 2.5L DOHC V6:
Click on the following direct, free Link. It has several Diagrams of the Timing Belt + Mark Diagrams for your 1989 Toyota Camry for either the 2.0L OR 2.5L. It also has additional - very helpful Instructional and Directional Diagrams..

Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!


http://www.2carpros.com/car_repair_information/year/1989/make/toyota/model/camry/1989_toyota_camry_timing_belt_diagram_marks.htm

May 11, 2010 | 1989 Toyota Camry

1 Answer

Cant find Toyota Camry 1989 Station Wagon fuse box


usually fuse box is located under the dash board on the driver side.

Apr 18, 2009 | 1989 Toyota Camry

Not finding what you are looking for?
1989 Toyota Camry Logo

Related Topics:

50 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...