The rear seat is probably bolted to the floor under the seat - thats if you are trying to remove it out of the car - my Q is what do you have to lift it up - usually seat cover wrap down and around and over the top. most covers have ties that are tied together for this - there is no reason that I see to pull the seat up- unless the bottom seat is right on the floor and that's why you are asking this - some rear seats have as they say hook into a bracket
SOURCE: The power seat in my 2000 Nissan maxima does not
your seat uses motors to move the seat you have probably knocked the connector off one of your motors
SOURCE: Just aquired a 1972 CB350
Usually, the front seat bracket has a bolt in it that when removed will allow the bracket to come off then allowing the tank and ruber mounting to also lift off and slide back. don't forget to turn the tank to off position and remove hose from carberator first!
SOURCE: how to remove bottom section
there should be a couple of bolts one on each side on the floor in front of the seat bottom remove and get in car put your hands down between the top and bottom seats and lift hard
SOURCE: "2008 nissan rogue problem shifting
It is the battery. It is bad and shorting out. Check the manual for directions to trouble shoot until you replace it. There is a small button that you need to remove next to the shifter, place the key in the hole and hold for about 10 seconds. It is a shift release.
I had the same problem. Fixed!
SOURCE: How to remove the rear
Pull up the seat cushion with a VERY firm tug upward on each side. There is a pin on each side (right where a person's legs would go about 12-15 inches in from the side of the cushion) that you need to disengage. But the cushion is not bolted down. This can be difficult so often repeated tries are needed.
666 views
Usually answered in minutes!
×