Need to find the IFS switch on my 2006 Mazda MPV. If I don't find it ASAP I am without transportation, & I have a kiddo who has to get to & from school. Help, please!

SOURCE: automatic door locks

faulty switch or relay or just a fuse

SOURCE: program remote control for mazda mpv 2002

Courtesy of: forums.mazdaworld.org

Try this, it works on several 2002 models:


Step 1: Open drivers door and leave open.

Step 2: Lock and unlock the drivers door using the power door lock switch on the door.

Step 3: Insert key into the ignition.

Step 4: Turn key to on position and return to off position. (IMPORTANT - use ON position NOT ACC position). Do this 3 times within 10 seconds. Leave key in the ignition.

Step 5: Open and close the drivers door 3 times. (Door should be left open after this step).

Step 6: ECU should respond by locking and unlocking the doors.

Step 7: Press any button on remote #1. ECU responds by locking and unlocking the car doors.

Step 8: Press any button on remote #2 (etc.) Each time the ECU will respond by locking & unlocking the doors.

Step 9: Remove the key from the ignition and the ECU will respond a final time with a series of door locks and unlocks. You're done

SOURCE: Drivers side window has slipped off track 2006 mazda mpv

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Pull back the weather seal and you can readjust the window mechanics.

SOURCE: HOW TO REPLACE 2001 MAZDA MPV SPARKPLUGS? PLEASE

All information is here: http://forum.mpvclub.com/viewtopic.php?t=25522

Doug Adams

• 682 Answers
• Posted on Jan 29, 2012

SOURCE: mazda mpv 2006 repack wheel bearing

There is a little difference between the front and rear. The days of packing wheel bearing is almost over. The front bearing you have to pull the hub and change to bearing. The rear wheel you have to change out the hub bearing and all. The front is a sealed bearing and not serviceable. Please rate my answer so I am rewarded points for it.

Testimonial: "Thank you for being so quick about responding to my question"