SOURCE: 1997 pontiac grand prix se has code po401. I
Check for
vacuum leaks on intake manifold,
the air tube between the air filter.
intake manifold vacuum hose.
===
clean throttle plate with Berryman carburator cleaner
SEE sample picture HERE
===
Also remove carbon built up behind the EGR valve and the EGR passage tube.
===
Vacuum leak WILL offset the intended 14.7 to 1 air fuel ratio.
More un-metered air (leaks) will lean out the fuel mixture.
Use small amount of Berryman carb clearer at potential air leak area will help you identify trouble spot.
At idle,just spray and listen for the RPM surge.
The in-rush of carb clearer will increase the RPM on the motor.
Record the problem spot(s) and address it later.
===
EGR carbon built up require 2+ hours to clean from start to finish.
You will need a new EGR base gasket before your start.
Locate and remove the EGR valve after the vehicle is cool down.
Carefully record the connector and vacuum line (for older vehicle) location by drawing an easily to follow diagram.
Remove the EGR valve.
Inspect the location of the carbon built-up inside the valve and the EGR passage tube.
SOAK these areas with WD-40 spary.
You will need a small screwdriver,cloth hanger and lot of newspaper and time to get this cleaning done right.
RE-SOAK the carbon and let it sit for over-night will also help.
One the last round,pass a shop vacuum of the EGR valve and the passage pipe.
Install the new EGR gasket and connectors.
Allow the vehicle to warm up outdoor to burn up any remaining WD-40.
Take it for a test drive.
Please rate my answer if it's useful to you.
Cheers,
Mustgo
SOURCE: have 1988 pontiac grand prix se with 2.8 v6
My sincere apologies for the delayed response.
I am personally going back to answer your unanswered question.
For the 2.8L
Firing Order:
1-2-3-4-5-6
Cylinders:
......(back)
1.......3.......5
2.......4.......6
......(front)
Ignition Connections (Spark Coils):
........(back)
.|.1..4.|.|.6..3.|.|.2..5.|
........(front)
Again my apologies....
Let me know if this helped...
SOURCE: i have a 1995 pontiac grand prix se the security
put the key in trun it on do not try and start it just trun it on. leave it on of 20 min.s then trun key off and try to start this should reset the computor.
98 views
Usually answered in minutes!
×