Can you undo the engine mounts from the bottom and jack the engine up with a floor jack? Be careful you dont dent the oil sump; recommend you use a block of wood as a buffer between jack and sump. Unless it has proper jacking points.
There may be better information in the repair manual:
'
Hyundai Tucson Repair Manual 2004 2009 Service Repair Manuals
SOURCE: The type of motor oil for my Tucson
just go to where ever u were planning to buy the oil from and tell them what type of car, make and year it is and they will give u the correct type
SOURCE: 2005 Tucson
camshaft sprocket bolt 58-72 ft. lbs. crankshaft pulley bolts 108-132 ft. lbs. crankshaft pulley center bolt 80-94 ft. lbs. cylinder head bolts cold engine 65-72 ft. lbs. warm engine 73-80 ft. lbs. cylinder head rear cover bolts 69-86 in. lbs. flywheel/Driveplate bolts 94-101 ft. lbs. intake/Exhaust manifold nuts/Bolts 11-14 ft. lbs. jet valves 13-16 ft. lbs. main bearing cap bolts 36-39 ft. lbs. oil pan bolts 51-69 in. lbs. oil pan nuts 43-60 in. lbs. oil pan drain plug 33 ft. lbs. oil pump cover bolts 72-84 in. lbs. oil pump relief valve plug 29-36 ft. lbs. oil pump sprocket nut 25-28 ft. lbs. Rear oil seal retainer bolts 84-108 in. lbs. rocker arm shaft bolts 14-15 ft. lbs. rod bearing cap nuts 23-25 ft. lbs. silent shaft sprocket nut 22-28 ft. lbs. spark plugs 15-21 ft. lbs. thermostat housing-to-Engine bolts 86-114 in. lbs. timing belt tensioner bolt 32-40 ft. lbs. valve cover bolts 43-61 in. lbs. water pump-to-Engine bolts alternator brace bolt 14-20 ft. lbs. all others 9-11 ft. lbs. water pump pulley bolts 72-84 in. lbs.
SOURCE: My washer fluid isn't working on my 2005 Hyundai
The fuse for the washer fluid is in the fuse box under the hood on teh drivers side.... There should be a diagram that will show you what fuse exactly.
SOURCE: how many bolts on the thermostat housing?
should just be two bolts, one on each end of the housing
SOURCE: How do i remove the front bumper on a 2005 Hyundai
Please leave 4 thumbs up for this answer.
Under the fron wheel arches remove the retaining screws that attach the splash shields to the bumper, Also remove the 2 screws under there that secure the bumper to the corner of the car panel. Remove the grill and supporting clips that attach the bar to the reo {reonforcement} underneath, remove the screws securing the stone shield panels to the bottom of the bar. If you have flood or spot lights, ensure their mountings are free from attaching between the plastic cover and the reo. The cover should pry away with very little force if any. Hope this helps you, safe driving.
Testimonial: "very helpful, Thanks"
100 views
Usually answered in minutes!
×