SOURCE: audi a4 wipers havejust stopped working
I have the same problem. Check this out.
http://www.audiworld.com/tech/misc44.shtml
I am working o it
SOURCE: audi a4 wiper stops anywhere after 10 sweeps
Hi - had the same problem with mine last year - turned out to be a sticky relay. You can probably hear it clicking with each wipe. These are well over £20 from the dealer, around £5-10 from a breaker, or if you like a challenge (like me) you can unclip the plastic cover off the relay and lightly dress the contacts with a nail board! Good luck.
SOURCE: 2000 Audi a4 headlight bulb replacement
The easiest way to do it is to pull the headlight out of the car. This isn't hard, but you'll have to have a T30 Torx bit to do it. There are three bolts that secure the headlight. Two are on top of the headlight - you'll see them right up there on top when you open the hood.
The third is harder to find. Look where the outer upper corner of the headlight meets the top of the fender, above the corner indicator. There is a lip on the fender that runs all the way back to the base of the windshield, where the edge of the hood sits when it's closed. There is a round hole in that lip near the headlight (just behind it). Shine a light down in there and you'll see the third Torx bolt. Take that out and you can slide the headlight assembly forward. You shouldnt' have to take it fully out of the car, just take the bolts out and move it forward.
Then remove the dust cap on the back of the headlight, pop the connector off the bulb, undo the spring clip holding the bulb, and remove it. Install the new bulb (wipe down the glass portion with your t-shirt to get any skin oils off it, as they'll burn it up quickly), and then reassemble in the reverse order.
SOURCE: 2000 Audi A4 radio code
check the owners manual or maintenance guide , some people handwrite the security code in.
SOURCE: Windscreen wipers not working. Is this the motor
I had this problem two years ago on my Audi A4. First you must diagnose this problem. In order to find out the cause of wipers stopping you can try follows: 1. Carefully extract the wiper arms from their axles (two pieces). In some cases you need to use an extracting tool. Heed of the windscreen !!! 2. Disassemble the plastic covers from the bottom of the windscreen. 3. With the bonnet up you can start the engine, (transmission in "N" or "P" position and parking brake on). Now you must switch on the control lever of the wipers, and go to the engine compartment. If the wiper motor runs let the wiper motor running for a few minutes and switch off. Go to the step 4. If the wiper motor do not runs you must check first the electrical feeding of the motor. It is necessary to unscrew three bolts of the mechanism and disconnect the electrical coupling (difficult assurance). If the electrical feeding is OK you must replace the motor - steps 5, 6, 7. If not you must check electrical connections, the control switch of wipers and electric cables. 4. Now you must check the two bearings of wiper mechanism with your hand. In the most cases the left bearing is out of order (is very hot). This is the most encounter fault of the wipers running at Audi. 5. For have enough space to manipulation the wiper motor together with their mechanism you must extract the plastic cover of the engine computer box, and extract also the box screws. Then you can move slowly the engine computer box, just for a few milimeters. 6. You must disconnect the electrical coupling of the motor (difficult assurance), unscrew three bolts of the mechanism and extract together with the motor. You must move them slowly between windscreen and engine computer box until the wiper motor go out together with the mechanism. This is the most difficult operation! 7. Now you can repair the bearings, replace entire wiper mechanism or replace the wiper motor. It is not very simply, but it works. Heed of the windscreen !!! Refit in reverse order. Please Rate my Response! Thanks!
184 views
Usually answered in minutes!
×