Where are the oil galley plugs on a 1993 jeep wrangler 2.5

http://www.amsoil.com/mygarage/vehiclelookup.aspx?url2=1993+JEEP+WRANGLER+S

usually ATF oil,fill to plug level

probly the shift rail worn have it checked also dirty oil can cause harsh shifting

Wrangler 6 cylinders engines are a straight 6 engine with only one valve cover. The gasket for the valve cover is sold separately from the entire valve cover so it can be replaced.

Find the pin switch on the front of the drivers side door jam, check the back side of the switch, (near the E brake pedal) make sure the plug is attached. It just plugs in. It is easy to plug and unplug the wiring to this switch on the YJ's so you can drive with the doors off and not worry about your interior lights being on and draining the battery when the engine is off.

Your jeep May Have a Blown Head Gasket..That Would Explain The Orange Color On The Plugs.

Jeep Wrangler/YJ 1987-1995 Repair Guide

Engine Oil


Fig. 1: Be sure to select the proper API quality classification and SAE viscosity grade of engine oil (10W-30)


Oil FIlter (K&N sample)


HP-2004 work for 2.5L and 4.0L


Manual Transmission
The level of lubricant in the transmission should be maintained at the filler hole on all manual transmissions. This hole is on the right side. When you check the level in the transmission, make sure that the vehicle is level so that you get a true reading. When you remove the filler plug, lubricant should run out of the hole. Replace the plug quickly for a minimum loss of lubricant. If lubricant does not run out of the hole when the plug is removed, lubricant should be added until it does. Replace the plug as soon as the lubricant reaches the level of the hole.



Fig. 1: Manual transmission fill and drain hole plugs

DRAIN AND REFILL
Remove the drain plug which is at the bottom of the transmission. Allow all the lubricant to run out before replacing the plug. Replace the case with the correct viscosity oil. All manual transmissions use SAE 75W-90 API quality Grade GL-5 gear lubricant. Tighten the fill hole plug to 27 ft. lbs. (37 Nm).


I hope help you with this (rermember rated this help) Good luck.

you have either water in the fuel, or you have a plugged catalytic convertor

Fill it with 10w30 motor oil.

Hi there.A auto parts store or a dealership service department can help you determine the type of fluid recommended for your vehicle.The fill area is also the full mark,when adding fluid to the transmission or transfercase the fluid will come out of the fill hole and thats when you will know it is full.Its hard to tell how much fluid is is needed, every vehicle is different,but I believe the transfercase is between 2-3 quarts and the standard tranny is between 4-5 quarts.Keep your receipt and whatever fluids you do not use you can return.Hope this helps.John.