1992 Mercury Grand Marquis Logo

Related Topics:

Mick Hawley Posted on Jan 02, 2017

WHERE IS THE LOCATION OF THE WIPER CONTROL MODULE ON A 1992 MERCURY GRAND MARQUIS LS0

5 Related Answers

Philip Armitage

  • 437 Answers
  • Posted on Aug 25, 2009

SOURCE: Where is the wiper delay control module located on

the module is located under drivers side dash right of the steering column. it is gray plasticmodule, the most common problem with these modules is soldering on the board. If you resolder these points the module should work for you.

Ad

Anonymous

  • 144 Answers
  • Posted on Sep 22, 2009

SOURCE: I have a 2005 Mercury Grand Marquis and I can't turn the wipers.

this is a very common problem on these vehicles. the wiper motor has a park switch built into it that fails. replace the wiper motor and this will stop problem. hope this info helps you!

Anonymous

  • 56 Answers
  • Posted on Jan 24, 2010

SOURCE: what is the spark plug gap specification for a

go to or call an auto pARTS STORE they can tell you the plug gap.

Anonymous

  • 5 Answers
  • Posted on Jul 10, 2010

SOURCE: Where is the headlight control module on 2005

your lcm is located under the steering wheel to your right its that rectangle box with a connector showing.

Anonymous

  • 5 Answers
  • Posted on Jul 10, 2010

SOURCE: how do I change out the Headlight/ Lighting

u can do it your self the lcm is a stand alone unit just unscrew dissconnect and reconnect and screw

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

1995 Mercury Grand Marquis. How many fuses does my digital instruments cluster have please?

Question edited for clarity.
Question moved to model category.

Here is your full fuse box diagram. If your cluster is dark, check the rheostat to adjust brightness. Got grandchildren that like to play 'driving the car'?

Fuse Box Diagram Mercury Grand Marquis (1992-1997)

https://fuse-box.info > mercury > mercury-grand-marq...

Here you will find fuse box diagrams of Mercury Grand Marquis 1992, 1993, 1994, 1995, 1996 and 1997, get information about the location of the fuse panels ..

..
0helpful
1answer

Location of 2 amp fuses in cruise control 1992 grand marquis

The cruise control fuse is a 15 amp fuse located at position #17 in the fuse block. That's the only fuse I see in that circuit according to My wiring diagram. I hope this helps. Take care.
0helpful
1answer

Where is wipers control module located on 1995 gran marquis

This is usually a contact inside the wiper motor. Some are accessible and some require replacing the wiper motor. The inside of the wiper motor jumps into a derailer which breaks the electric contact that keeps the motor turning. Once the motor cycles, it parks in the down position.

The insides of the wiper motor are suppose to coast without power into the Park position.
0helpful
1answer

Wiper dont work

Check all your fuses and breakers first. With the ignition turned to run check that you have power at the WCM, wiper control module, check the multifunction switch the wipers run off of, check wiper motor or linkage under the plastic cowling under the wiper blades, comes off easily with a few screws and clips.
0helpful
1answer

Which fuses control the radio in a 1992 grand marquis

either the cigarette lighter or the designated radio fuse located inside the car, usually under drivers' side dash.
2helpful
1answer

Where is windshield wiper motor for 1992 mercury grand marquis

1992-98 Vehicles
  1. Disconnect the negative battery cable.
  2. Remove the rear hood seal. Remove the wiper arm assemblies by raising the wiper blade off the windshield. Move the slide latch away from the pivot shaft and slowly lower the arm onto the latch. This unlocks the arm from the pivot shaft and holds the blade off the glass. Pull the arm from the pivot shaft.
  3. Remove the cowl vent screws and disconnect the washer hoses from the washer jets.
  4. Detach the electrical connectors from the wiper motor.
  5. Remove the wiper assembly attaching screws, lift the assembly out and disconnect the washer hose.
  6. Unsnap and remove the linkage cover.
  7. Remove the wiper module assembly retaining bolts and remove the module from the vehicle.
  8. Remove the linkage retaining clip from the motor operating arm by lifting the locking tab and pulling the clip away from the pin.
  9. Remove the motor retaining screws and remove the motor from the vehicle.
  10. The installation is the reverse of the removal.

ad37f8d.jpg

Fig.: Lift up to release the clips and remove the hood-to-cowl weather strip


ca6ea0f.jpg

Fig.: Remove the cowl panel-to-firewall retaining clips



Remove the driver's side then the passenger side cowl panel from the vehicle


d57f264.jpg



Fig.: Detach the electrical connector for the wiper motor

Release the wiper motor retaining clips and remove the cover from the vehicle


ffed3a6.jpg



Fig.: Remove the wiper module assembly retaining bolts and remove the module from the vehicle


412221d.jpg



Fig.: Remove the wiper motor retaining bolts and ...


46edc09.jpg


Fig.: ...remove the wiper motor from the vehicle




Hope helps (remember comment and rated this).
2helpful
2answers

Location of light control module for 2003 grand marquis

above brake pedal. You can get it out w/o removing anything else.
buy from tascafordparts.com at discount. Expensive!!!
1helpful
1answer

Computer control module

look below the brake master cylinder. i think thats where thet still are.
1helpful
1answer

How do you remove windshield wipers on a 1997 mercury grand marquis?

If your'e just removing the wiper blade, check for a "release lever" where the wiper attaches to the arm, push (or pull) the lever and pull down on the blade at the same time. Do the opposite to install, except you do not have to push the release lever.
If you are removing the whole arm, there is a special tool that you slide under the arm that releases it from the 'gear'.
0helpful
2answers

Wiper speed control for a '97 Mercury Grand Marquis. What causes the wiper to work on high speed only?

Intermittent wiper control stopped working on my 1996 GM last spring. I ended up replacing the wiper motor ($100.00 part). Since I have found it on Amazon for $58 including shipping. It works fine now. Only bad part was all the "stuff" that has to come out (like dead leaves!) to get to the wiper motor. Also make sure you have your wipers in the down position when you replace the motor.
Hutch50
Not finding what you are looking for?

528 views

Ask a Question

Usually answered in minutes!

Top Mercury Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...