I have found the instrument panel fuse block. How do I remove the cover for the fuse block ??

he fuel pump fuse on a 1991 Buick Century V6 is located in the instrument panel fuse block.
To access the fuse block, you need to open the driver's side door and remove the cover located on the side of the dashboard. The fuse block should be visible behind the cover.
Once you locate the fuse block, look for the fuse labeled "Fuel Pump" or "FP." The fuse should be a 20-amp fuse, and it is usually located in the bottom row of the fuse block, second from the left.
It's important to note that in some cases, the fuel pump fuse may be integrated into the main power distribution center under the hood. If you're unable to locate the fuse in the instrument panel fuse block, you may need to refer to the vehicle's service manual or consult a qualified mechanic for further assistance.

Maxifuse@/Relay Center: To check the fuses in this underhood fuse center, turn the two knobs one-quarter of a turn to the left (counterclockwise) and loosen the metal wing nut on the passenger's side of the cover. Then remove the cover. The inside of the cover has a chart that explains the features and controls controlled by each fuse and relay.

There are two fuse blocks in your vehicle: the driver's side and passenger's side fuse blocks. Driver's Side Fuse Block - The driver's side fuse block is to the left of the steering wheel, under the instrument panel. Snap off the cover to reveal the fuses. You'll find a fuse puller clipped to the inside of the cover. Place the wide end of the fuse puller over the plastic end of the fuse. Squeeze the ends over the fuse and pull it out. Spare fuses are located in the slots labeled "Spare" on the following chart. When finished, replace the cover by snapping it back up into place.

Additional fuses are located in the relay center, on the passenger's side, below the instrument panel. You must remove the sound insulator on the right side of the passenger footwell to replace these fuses.

Open driver side door, remove fuse access panel on the left side of the instrument panel and check the instrument cluster 10A fuse behind on the fuse block (third row from the top, fourth fuse position note: first two position may be empty). If fuse checks out the connector behind the instrument cluster may have worked loose. Remove steering column covers, remove bezel around the instrument panel (this is held on with push clips), remove four screws from the cluster and ease the cluster out just enough to see and correct the problem. hope this has helped.

Hi,
You have a 10-amp mini fuse in the fuse box under the hood in the engine bay fuse block. And you also have a fuse in the RH lower corner for the stop lamps which is a 20 amp fuse.
Check these and let me know.
THanks
Jason

Hello: Instrument panel fuse block- located on the instrument panel (passenger side consel) near the
floor. Remove the panel then the fuse block cover. Engine compartment fuse block: Under the hood on driver side near the battery. You may have to remover cover to access the fuse block. Rear compartment fuse block Located in the trunk. Access the fuse through the trunk panel on the driver side. The inside of the fuse block covers give you the location, size of fuse and purpose. Hope this helps.

The fuses are located on a fuse block, they provide increased circuit protection and reliability. The fuse block is located under the left side of the instrument panel and steering column. The fuse block should be visible from underneath the steering column, near the pedal bracket. If the block is not visible, check for a removable compartment door or trim panel which may be used on later models to hide the block. On 1996-97 models, there is also a fuse/relay panel mounted underhood.



Fig. 1: If the fuse panel has a concealed cover, unscrew or unclip the retainer and remove the cover:



Fig. 2: Some fuse panel covers contain a fuse puller, spare fuses and a diagram of the fuse locations:

Good luck (remember rated this help).

The fuse block on most models covered by this manual is located under the instrument panel to the left of the steering column. The fuse block should be visible from underneath the steering column, near the pedal bracket. If the panel is not visible, check for a removable compartment door or trim panel which may used on later models to hide the block.



Fig.: The fuse block on most models is located under the instrument panel to the left of the steering column

Hope helps (remember rated this).

under the glove box, you'll set a panel with 2 plastic pressure pins. using a pair of pliers, just pull from the center and remove both of them. the entire panel will be free, and the fuse block is on the far right side, (closest to the passenger door) you'll need a good light and small hands....the engineers did NOT give you a lot of room in there!

The interior fuse panel can be found below the instrument panel and the exterior fuse panel beneath the hood, near the battery.

1. Remove the fuse panel cover.
   
2. Locate the fuse to be removed.
   
3. If equipped with a small fuse removal tool (usually attached to the inside of the fuse panel cover), use the tool to grasp the fuse. Otherwise, you can use your fingers to pull the fuse from the panel. Remove the fuse and inspect it to see if the filament is blown.
   
4. If the fuse is blown, replace it with a fuse of the same amperage rating.
   
5. Replace the fuse removal tool, if applicable, then install the fuse panel cover.
   
6. If the fuse continues to blow, check the circuit or component that the fuse is protecting, and repair it as necessary.
   

The interior fuse panel is located below the driver's side of the instrument panel

It is fuse number 15 and it is a 30 amp.