2004 GMC Envoy Logo

Related Topics:

Joe Russell Posted on Dec 06, 2016

Where is the fuel injector located?

2004 GMC Envoy SLT 4.2L engine will turn but want start i want to test for injector pulsa but i don't know where it is i believe this vehicle have a throttle body can you send me pictures showing how to test for injector pulsa.

5 Related Answers

Anonymous

  • 31 Answers
  • Posted on Dec 11, 2008

SOURCE: replace starter on 2002 GMC Envoy SLT

check to see if the starter itself is getting a signal to crank. youll need to use a test light and have someone else try to start the vehicle, while you probe the wire to the starter to see if it is getting power. if not, check the starter fuse to make sure its not blown, as well as the starter relay to make sure that is good too (very common on gm's for bad relays) if the fuse and relay are good, but your not getting signal, it is an ignition switch problem.

Ad
emissionwiz

Marvin

  • 85242 Answers
  • Posted on Apr 26, 2009

SOURCE: charge ac

It is located under the hood in the larger of the 2 AC lines, this large line is the low pressure line, also check on the round can the low side line connects to as it can be on that as well, that part is called the Accumulator/reciever drier

reiner jensen

  • 38 Answers
  • Posted on May 06, 2009

SOURCE: 1988 gmc k1500 wont start

hi, check the connections at the ecm,i think it's under pass front seat,i've had a couple of those years loose injector signal at ecm connector,if you have a test light you can unplug injectors and test across terminals ,it's a 12v signal at inj ,if lights flash on both while cranking try plugging in one at a time and see if either sprays, if one does and not the other, you would have a shorted injector

jagjeffery

Jeffery Lewis

  • 329 Answers
  • Posted on May 31, 2009

SOURCE: throttle body injectors not fiering but there is fuel pressure

the injectors are fired thru the engine cotrol module but it gets its signal to fire from the pick-up located inside the distributor if you are loosing injector pulse only the ignition module is bad if you are also loosing spark when you loose injector pulse your pick up is causing the problem if you replace the pick-up i recomend you change the ignition module when doing so because they work together and you have to remove the distributor to change the pick-up

ROB

  • 858 Answers
  • Posted on Aug 15, 2009

SOURCE: 92 gmc pickup,fuel injected throttle body.Engine

electronic dizzy modules do this when they get warm they cut out but can start up again within minutes !
very commen fault!
get it checked or borrow one
Cheers Rob

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

2005 GMC Envoy SLT. It will not start.

I wonder if the Immobilizer is related to the door locks and the fuse blowing broke the pairing. Try the reset

https://www.google.com/search?q=2005+GMC+Envoy+SLT+reset+security

..
0helpful
1answer

Where is the CD player fuse located on a 2004 GMC envoy SLT 4.2L?

I take help from online websites that have this service like helping in repair some like reliable-store have instant help.. others are a bit slow which I don't prefer... rest is up to u.. U can also get free manuals
1helpful
2answers

How does the crankshaft position sensor operate what is it Job to do? and how do i test the injectors for pulsa with a noid light where are the injectors located on this vehicle?

The crank sensor is needed for the coils to fire. It is on the drivers side, mounted in the engine block back by the transmission. The injectors are under the plenum. The plenum wraps around them. I wouldn't worry about them right now. And your probably right about being flooded. I would throw new plugs in it when you replace the sensor.
0helpful
1answer

I been turning the engine over a lots but i don't smell any fuel shouldn't the engine be flooded by now? there is no spark at the spark plugs.

something is stopping the fuel and spark
items that prevent those things are
broken timing belt /chain
problem cam/crank position sensors
immobilizer problem
ECM problem
0helpful
1answer

Where is the purge control solenoid and powertrain relay located on 2004 Envoy SLT 4.2L?

Powertrain relay ? Maybe you mean IGN 1 relay ? This supplys B+ power to the coils . relay # 58 in the under hood fuse box .
Is there B+ voltage at the coil's pink wire ?
Evaporative Emission (EVAP) Canister Purge Solenoid (LL8)
On the left side of the engine block
Engine Controls Component Views in Engine Controls - 4.2L
Engine Controls Connector End Views in Engine Controls - 4.2L
Evaporative Emission (EVAP) Canister Purge Solenoid (LM4)
On top of the engine, toward the front
Google picture of solenoid so you know what your looking for .
0helpful
2answers

Do a 2004 GMC Envoy Slt 2.4L have a ignition module?

correction this is a 4.2L not a 2.4L
Do a 2004 GMC Envoy Slt 2.4L have a ignition module?
The engine will turn but want start no spark at the spark plugs boot what could be the cause no spark? AmanStino 3 USB ports Car charger with 1 Type port AmanStino
1helpful
1answer

The engine will crank but will not start why?

Do you have any codes or an engine light on, in your dash board ? Have you checked for spark at your plugs ? There are many things that could cause a vehicle to not start. Bad camshaft/crankshaft sensors. Poor ground wiring. Defective spark plugs or wires/coils.
1helpful
1answer

2004 ENVOY WHERE IS MODULE RESISTOR

2002 - 2009 GM BLOWER MOTOR RESISTOR - YouTube

? 4:17
https://www.youtube.com/watch?v=WWi-_-kY-dM
Sep 5, 2012 - Uploaded by davesgarage512
I have a 2003 GMC Envoy and my issue is when I shut the blower off it still ... Can this issue also be remedied ...

2004 GMC ENVOY Blower Motor Control Module / Resistor



0helpful
1answer

I dont know how to turn the heated seats on?

locate the heated seat button and the heated seat should start to work
1helpful
1answer

2004 GMC Envoy SLT possible electrical problems

it sounds like you need a regulator for your alternater it is reversing polarity there for draining your battery and reseting the clock. it is located on the back of your alternator.hope this could help.
Not finding what you are looking for?

76 views

Ask a Question

Usually answered in minutes!

Top GMC Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

john h

Level 3 Expert

29494 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...