My left door will nt unlock when pressing unlock button 2006 gs 300lexus

batttery remote ok?

Could be a wire left off the starter .

did some quick research for you and found this easy and very clear step by step instructions on how to program your transponder car key to your vehicle.. this works for the following models though :

Accord 2003 to 2006

Civic 1999 to 2006

Element 2003 to 2006

Odyssey 1999 to 2006

Prelude1999 to 2001

Accord SE 1997

CR-V 1998 to 2006

Insight 2000 to 2006

Pilot 2002 to 2006

now here are the steps:

1. Turn the ignition on
2. Press Lock/Unlock within 4 seconds
3. Turn ignition off and hen back on within 8 seconds
4. Repeat steps 2-3 two times
5. Press Lock/Unlock again within 4 seconds. The system should now lock and unlock the vehicle to indicate it is in programming mode.
6. In the next 10 seconds: press Lock/Unlock button allowing the doors to lock/unlock once; then press lock/unlock button of each remaining key, allowing the doors to lock/unlock once.
7. Switch ignition off and then remove the key

Civic 1996-1998

1. Turn ignition on
2. Press and hold the valet button which is situated on the radio within 5 seconds.
3. System should now lock and unlock the vehicle indicating it is in the programming mode
4. Within 5 seconds turn ignition OFF and press Lock/unlock on the remote fob to be programmed
5. Within the next 10 seconds, press Lock or Unlock of any remaining keys, allowing the doors o lock or unlock once.
6. Release valet key
7. Switch ignition off and then remove the key

Radio remotes 2 and 3 button types

1. Switch ignition on and repeat for 3 times.
2. Press he lock button, switch the ignition off and back on and then press lock button again.
3. System should now lock or unlock
4. Press the lock button of all remotes to be coded. The car should acknowledge this by locking/unlocking each time
5. Switch ignition off to exit the programming mode.

If you will have any further doubts or question to ask i suggest you to check out the page where i found this which is http://www.carkeyadvice.com/step-by-step-fob-programming-guides/honda :) i hope this was the solution you were looking for mate! happy happy new year!

how do I reset one of two keys that the unlock,lock,trunck does't work but the key turns the engine over.

I believe you have to press the button very quickly 2 times. One time is just for the drivers door then two times very quick to unlock all..

you have to press it twice to unlock all doors or lock all doors.

Did you try with the key? The keyhole is in the top left corner in the trunk by license plate (opposite to the camera lens).
Also, make sure the valet button in the glove compartment is released (or pressed)

push down on trunk slightly then unlock, when open lubricate locking mechanism, if rear seat folds check for Florissant handle to open

Sounds like you need to reset the auto up/down feature. Most vehicles require you to "roll" the window down, hold for 10 secs, roll the window up, and hold switch for 10 secs. This should reset it. If not, you may need to do reverse of what I said.

Chris,

I know you have the solution by now by Im submitting this post anyway.

To reset the oil maintence:

Have the car in a secure location with the engine off

1. Press the ingition button once, do not have your foot on the break pedal
2. Make sure you have the instrument cluster (panel on left hand side below gauges) open
3. The button marked "reset" depress it for 30 seconds and the "oil maintenance," should be reset.

Hope that helps.