Airbag light The airbag light stays on all the time. It blinks when I first start it then stays on. I bought this car last Sept. and I think its a dud.

The flashing light on your car is telling there is a problem. On some vehicles require a OBD2 code scanner for the diagnosis. Once you know the code, you can most likely repair it yourself.

Poor connection on yellow connector under a seat causes problem. If blinks two times x 9= driver side problem if two+tree times = passenger side .This connector supplies power to airbag installed in a seat . Try first to move connector or pull wires gently to gain contact . If on another restart works fine you solved it but it wont last because wire contacts are loose . Use imagination how to gain permanent contact! i have used soldering method after a few times had to take seat out. Problem is if more than one driver drives a car and seat adjustment is needed regularly.
Hope it helped to someone...

The flashing light means there is a problem with the SIR system. When the light stays on the system is disabled.
You will have to take it to a shop to get it scanned to find out the problem.

{: ) If the airbag light goes off after that 7 blinks (some are 6 or 8), that will be normal. The airbag module will blink the airbag warning light on the cluster while performing self-test during initial start-ups. After the self-test and the airbag module did not detect any fault within the airbag system, it will turn the warning light off. If the airbag warning light continuously blink or stayed lit after the expected elapse time, then there is really a concern and you need to double check the airbag system with a scan tool.

Guys! Are you readying your airbag system after messing around with your truck?

I've seen airbag lights come on for man reasons, faulty sensors, connections, replacing RADIOS! Removing seats!! All sorts of reasons. Personally I bought my QX56 with the airbag light blinking. Drove me crazy for 24 hours till I decided to reset it n see what happened. It takes two minutes to do. No tools.

1. Turn key from off to on. (on meaning all your dash lights are on but your not cranking the motor)

2. Watch the airbag light closely. It will stay on for a few secs. and then as soon as it blinks off (the start of the flashing), turn the key off instantly.

3. Count to 5 (1 Mississippi, 2 Mississippi . . . .)

4. Repeat steps 1-3 two more times until you have done the cycle three times.

5. Now turn the key on and watch the light. It will start blinking in a different, slower manner. This is diagnostic mode. You can watch this for a little while, no hurry.

6. Now turn the key off again, Count to 5 like in step 3 again, and turn back on. If the procedure worked, the airbag light will not be flashing.

The blink code you are refering to is : Intermittent or Repaired RH Radiator Primary Crash Sensor Feed/Return Circuit Open , which means your right hand side frontal crash sensor (airbag sensor) is not working, therefore your airbag system is disabled...

my airbag light is blinking . can i reset anything its a04 nissaun armada

Take it to an independent specialist mechanic to get the codes read and a suggested plan of action

Hey,
take a look at www.airbagmodul.com

They're working in Airbag-Simulators and Occupancy Sensor-Simulators.

Regards

Gerrit

The wires going from to the airbag plug could have been pinched at reinstallation.I think that the ignition switch was replaced and it is very easy to pinch the wires from the airbag plug.One has to be very careful when reinstalling.