you replaced cam? or cam shaft sensor? if u just replaced camshaft sensor. its probly the timing chain. it slipped and now u need to retime the engine after u install new timing set

Oct 11, 2012 | 2001 Chrysler Concorde

1 Answer

Where is camshaft sensor bank 1 located in 2007 Chevy Aveo sedan?

On the 1.6 liter the value cover and upper timing cover need to be removed to replace the cam sensor. It will be mounted in between the two cam gears.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Aug 15, 2012 | Cars & Trucks

1 Answer

After receiving the error code p0036, (Heated o2 sensor 1 Bank 1) I replaced my o2 sensor, Cleared the computer and drove it for a day in a half.... Then the Check Engine Light came on again. After...

did you check your o2 sensor fuses?

Apr 04, 2012 | Cars & Trucks

1 Answer

2003 pt cruiser turning over but not firing?

048 Engine Hard to Start or No Start Scan Data for Starting Problems... Do you know what scan data is ?

Jun 27, 2017 | 2003 Chrysler PT Cruiser

2 Answers

How replace timing chain and align the timing marks also replace the front oil seal for a 2001 Chevy Cavalier 2.2L

I have the instructions but they are long and will not entirely fit in this forum. [email protected]

May 02, 2011 | Chevrolet Cavalier Cars & Trucks

1 Answer

The 12 volt battery(LUCAS 065/3) on my FORD FIESTA 1100cc is 4 years old, in that time i have only driven 1,600 miles as my journeys are usually very local. I make sure i use the car twice a week to keep...

Running so few miles has accelerated the aging of the battery - the battery never had a chance to fully recharge in such small trips - so now you have to replace it a year sooner than usual.
Just replace it.

Aug 28, 2010 | Ford Escort Cars & Trucks

2 Answers

I just bought a 2001 bmw 325ci the car had a rough idle when i drove it home and the check engine light came on. after about 10 min i took the car out the light went off i went to the gas station and...

Welcome to the world of BMW's. return the car to the seller. you got a bad one. You got an electrical short draining the battery. Bring a blank check and sign it over to the dealer. They're going to have to run through the entire electrical system to find the short. That work alone is worth more than the a used up 2001 325i.

Jun 07, 2010 | 2001 BMW 325

1 Answer

No spark after cam sensor replaced - Frustrated!

hallo
check sensor: disconect conector. you have 3 wires. first(green) and last(black) are suppy should be around 5V. if not check wiring.
If ok: conect conector and access conector terminals (or wires) and conect LED test lamp between terminal 3 (black) and 2 (also black).briefly krank engine. Check that LED flashes.
hope it helps
Marko

Sep 10, 2009 | 2006 Fiat X1/9

1 Answer

I'm getting the engine light coming every so often. It seems that after I fill the tank and get down around 3/4 tank, The message I'm getting is "EVAP Emission Control System Purge Flow Fault". PO441 and...

I have a 2004 dodge stratus 2.4 dual overhead cam. When driving down the road, bell goes off, check engine light comes on, and it's like I'm driving on limp mode, when going over 2000 rpm's, there's a severe stutter. After getting code for light it points to cam shaft sensor, which i changed. I also changed crank shaft sensor. After all of this was done, drove great for about 30 miles and the same thing happened all over again. If anyone can point me in the right direction it would be greatly appreciated.

Jul 05, 2009 | 2004 Dodge Stratus

Not finding what you are looking for?

View Most Popular

Cars & Trucks

1996 grnd voyager se, just replaced cam shaft position sensor (P0340).When the Service light came on first time my friend told me press gas pedal to restart even though is fuel injected car and the car...

1996 Plymouth Grand Voyager

Open Questions:

0 Answers

Ask a Question

Usually answered in minutes!

Check Out the Latest Top Trucks Report!

View all Fixya Reports

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Have a manual for BMW Cars & Trucks? Or just drag it here!

Car broke down,everything just went off,had new cam shaft sensor fitted and a new battery,it drove for 1 day,and now its flat again,what could drain a new battery or is it a bigger problem.bmw3 series

Add Your Answer

Attachments: Added items

Related Questions:

1996 grnd voyager se, just replaced cam shaft position sensor (P0340).When the Service light came on first time my friend told me press gas pedal to restart even though is fuel injected car and the car...

I have a 2001 chrysler LXI that is running UNHOOKED from the cam shaft!

Where is camshaft sensor bank 1 located in 2007 Chevy Aveo sedan?

After receiving the error code p0036, (Heated o2 sensor 1 Bank 1) I replaced my o2 sensor, Cleared the computer and drove it for a day in a half.... Then the Check Engine Light came on again. After...

2003 pt cruiser turning over but not firing?

How replace timing chain and align the timing marks also replace the front oil seal for a 2001 Chevy Cavalier 2.2L

The 12 volt battery(LUCAS 065/3) on my FORD FIESTA 1100cc is 4 years old, in that time i have only driven 1,600 miles as my journeys are usually very local. I make sure i use the car twice a week to keep...

I just bought a 2001 bmw 325ci the car had a rough idle when i drove it home and the check engine light came on. after about 10 min i took the car out the light went off i went to the gas station and...

No spark after cam sensor replaced - Frustrated!