My 07 nissan murano rear windshield wiper doesn't work properly it goes the wrong way, not on the window.

"If the windshield wiper fluid of your Chevy Equinox ends up on the rear window instead of the windshield, there could be several possible causes:

Damaged or incorrectly connected windshield wiper fluid tube: The tube that carries the windshield wiper fluid from the reservoir to the base of the front windshield wiper may be damaged or not connected properly, causing the fluid to leak elsewhere.

Clogged windshield wiper fluid outlet: The outlet of the windshield wiper fluid on the base of the front windshield wiper may be clogged with dirt or debris, causing the fluid to flow onto another part of the car, such as the rear window.

Windshield wiper system issues: There may be a problem with the windshield wiper system of your Chevy Equinox that causes the fluid to leak onto other parts of the car instead of the windshield."

Rear Wiper/Washer System Components
The rear wiper/washer system consists of the following components:
• Rear wiper/washer switch
• Window wiper module-rear
• Window washer pump-rear
• RR WIPER 15A fuse
• RR WPRB 25A fuse
Rear Wiper/Washer System Operation
The rear wiper module controls rear wiper motor operation. Battery voltage supplied to the module is used to operate the wiper motor in all modes and to return the rear wiper arm to the park position after the ignition is turned off. Accessory voltage supplied to the rear wiper/washer switch is used to supply the rear window wiper and washer switch signal circuits. In wiper switch positions 1 and 2 the wiper switch signal circuit voltage level to the wiper motor module determines the wiper motor delay interval. The rear window washer pump supply voltage circuit is used to provide the operating voltage for the rear washer pump for as long as the rear washer switch is pressed. The rear window washer switch signal circuit is used as a wash signal to the rear wiper motor module to operate the wipers during the rear wash operation.


Did you replace the rear wiper module ?

check for a bad connection at the wiper motor.

do you have a hitch? installed by someone else other than nissan dealer such as u-haul or others??lets start there

there is a clip that holds the arms in place and it slipt off track dealer sugests that u buy the part, the complet asembly costs about 140 dollars. u can take the cowl apart and slip it back on but i will slip off again and, and all because a stuped plastic cllip that they dont sell separete. hope this help...

The fluid for both windows comes from the front resivoir. The pump there is suited to pump either to the front or to the rear based upon your operation of the switch & if the rear isn't working, the line will need to be removed near the pump & checked for obstructions.

These can be cleaned with a vacuum tester, the kind that lets you pump the unit & draw a vacuum, connected to the hose, it will draw any debris back out of the tube. You probably don't want to try & force fluid through the hose as it won't fit through the washer nozzle.

good luck

sounds like thats it, you can check it for power,to make sure but it does sound like the motor.

Hello angela_brosc. My name is Roger and I will help. The Rain-Ex weather beater wiper numbers are. Driver side RX30226 and the passenger side number is RX30218. There is not a listing for a rear wiper blade. Should you need further help please just ask. Please rate the answer you received. This wat I know it was helpful. Thank You for using Fix Ya. Roger

You probably already figured this out, but you have to remove the wiper arm completely in order to replace the wiper blade.

The blades are an unusual size (somewhere around 14 1/2") and I believe they are only available from a Nissan dealership. They include printed instructions in the box but just in case, this is from the official Nissan service manual: