Starter interupter gps removal 2010 impala

SOURCE: 2007 Chevy Impala LT stock stereo

pop out the center trim piece with a flat head screwdriver. Center dash piece may be brushed aluminum or wood grain depending on trim level. It should pop out easily working all the way around it. Then radio is held in with 7mm screws.

SOURCE: Chevy S10 Pickup Starter. Removed the two bolts

Just changed a starter in a 94 S10 4x4. The only way to remove the starter was to take the passenger side exhaust manifold off and bring the starter out that way. Installation the same in reverse. Hope this helps. Don

SOURCE: remove rear seat impala2007

To remove the rear seat, pull up on the front of the seat bottom, it should be hooked in place by spring type clips. After you get the front edge up, pull out the seat. This should expose the bolts/screws that hold the seat back in. Look below and there should be a couple of screws holding the seatback to the car body. Remove these and then you can pull the seat back out of the car.
K

SOURCE: how do you remove the old car battery on a 2008

1. Disconnect the negative battery cable.
   
2. Remove the right front diagonal brace. The brace goes from the rad support to the fender area.Three bolts need to be removed.
   
3. Reposition the positive battery cable terminal cover (1).A red cover over the positive cable at the battery.It pops off.You may need a screw driver to pop it off.
   
4. Loosen the positive battery cable terminal nut.
5. Remove the positive battery cable terminal from the battery.
6. Reposition the underhood accessory wiring junction block.See steps 9-14.
   
7. Remove the battery retainer bolts (1) and retainer (2).
8. With the aid of an assistant, remove the battery.
9. Remove the electrical center cover (1).
10. Disconnect the positive battery cable from junction box
11. Remove the fasteners (1) securing the electrical center board (2).
12. Unlock the tabs on the electrical center board.
13. Lift up on the electrical center board.
14. Remove the fasteners (1) securing the electrical center bracket (2) to vehicle.

Ronny Bennett Sr.

• 6988 Answers
• Posted on Jan 24, 2010

SOURCE: I replaced the ignition in my 04 chevy Impala and

You have to have the key coded with the ignition switch at a lock smith,or the dealer.