How to replace motor mounts on 2003 hyundai sonata

Here's a guide Carlos,

This could be caused by a loose motor mount or a faulty tranny mount ...let me know if this is your concern and i can give you directions on replace ----step by step

the torque spec's are 71-89 inch pounds. start with the center bolts then work out in an opposite, (criss/cross) pattern, like you would tightening wheel lugs. please rate if this helped!

Replace spark plugs, wires, and air filter, and fuel filter it is available

Good luck. The last time I worked on one of these vehicles, I had to remove the engine mounts and tip the engine forwards so good luck..

For 2003 Hyundai Sonata 2.7 liter DOHC V-6 check this schematic...



Hope help (remember rated this) Good luck.

There are Two Balance Shafts on the 2.4. Did your mechanic also change the balance shaft belt when he changed the timing belt? If he didn't, you'll want to do that. Since you mentioned the old belt was missing teeth, those loose teeth flying around could have damaged the crank position sensor and sensor blade (tone wheel). Also, the front balance shaft (on the side of the engine nearest the radiator), has THREE different positions when the timing mark is lined up - here's the glitch - ONLY ONE of them is the correct one - this is probably where your vibration is.

i would because if there ever really is a problem you won't know because the light is already on