How to replace a control arm on a 2002 Buick Century

SOURCE: Orifice Tube - 2002 Buick Century

Some are in the inlet to the evaporator and some could be in the condenser line. You can get a new orifice tube on autozone for $5 - 20

http://www.autozone.com/N,16301861/shopping/partTypeResultSet.htm

SOURCE: how to replace a coolant level sensor, 2000 buick century

The coolant level sensor is located on the radiator. If you are looking at the engine from the front of the car it will be on the left side. There will some kind of clip holding it in the radiator. Removed the clip and pull the sensor out. You will lose coolant so try to swap it out quick or drain some of the coolant out. Once new sensor is installed, install clip to keep the sensor in place and reconnect the wires to the sensor. Crank the engine and make sure the coolant level is full. This should correct your problem.

SOURCE: Lower Control Arm Bushing replacement

Hi,
I just did this job on my 98 regal, and I own the service manuals also. The lower control arm bushing that usually goes, is the front one. The rear one doesn't usually go, it is horizontally mounted. The front one for some reason is vertical. The control arm must be removed, and put in a vise. The front bushings outer metal sleeve, must be driven out with a chisel. It comes out easily. The new bushing can be tapped in with a hammer. Hope this helps!
JOEVETTE

SOURCE: How do I replace broken 2002 buick century passenger side mirror?

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door

SOURCE: 1991 Century Buick V6 starter replacement.

remove the positive battery cable from the post
remove the 3 wires from the starter and the two bolts holding the starter to the block.
reverse the procedure for installation.

Testimonial: "I know that there is usually only 2 bolts to remove a starter. I've identified one bolt but was not sure about the location of the other one. Thanks"