My wireless lock stop working - 2011 Toyota Sienna

You have to reset key to door lock. Hold key near door and press unlock for a few seconds. Should reset

You may have to reprogram the keyless entry system hold the lock and unlock on the keychain you should hear the horn

are your batteries dead in all keys?

faulty master switch ..replace

looks like car has other issues as well.. but try that first

Do not leave key in ignition while doing this! First get the hood open and disconnect the battery from positive side. All doors closed lock or unlocked dosen't matter. Wait about 2-3 min.carefully reconnect the positive cable and tighten,car should go into combination of locking modes.Next your key push one time lock and hold unlock for 2-3 seconds or push the unlock twice.Locks should function properly lock to unlock and reversed.Normaly this resets all electronics to ECU.

Look for the power locks (power) fuse in the cabin fuse by the steering column, if that fuse is ok, you may have a body ecu problem.

If you need further help, I’m available over the phone at https://www.6ya.com/expert/flavio_517b938f50183b92

It may just be a bad connection in the switch of the drivers door since it works with the wireless remote

See if there is a fuse for your door locks.

Good Luck!

YOUR WIRELESS CONTROL MODULE(SENTRY KEY MODULE)MAY BE ELECTRICALLY LOCKED UP..THERE IS A SERVICE BULLETIN FROM CHRYSLER..YOU CAN REMOVE IOD FUSE IN FUSEBLOCK(UNDERHOOD BEHIND AIR CLEANER..IGNITION OFF DRAW(IOD)THIS WILL RESET WIRELESS CONTROL MODULE AND VEHICLE SHOULD START AND LOCKS RESPOND AGAIN..IF IT DOES,THE WCM WILL HAVE TO BE REPLACED AND THIS NEEDS TO BE DONE BY DEALER

Check out page 57 of the manual:

http://www.motorcraftservice.com/pubs/content/~WO6FOC/~MUS~LEN/41/06focog4e.pdf

If that doesn't work, it sounds like a trip to the dealer.