Cars & Trucks Logo

Related Topics:

W
Walwyn Jenkins Posted on Oct 07, 2016

Where is the Airbag control unit located in a 2010 model Mahindra ute

2010 Mahindra PICKUP

3 Related Answers

Neil Hansen

  • 40 Answers
  • Posted on Aug 02, 2010

SOURCE: Hi, have latest 2010 LC79 Toyota Landcruiser V8

The starter motor is buried in the V8 valley . It is about a days work to replace it . They are very expensive , have only a few service parts and don't like water .

Ad

Anonymous

  • 1 Answer
  • Posted on Dec 23, 2010

SOURCE: Oil filter location on 2010 Toyota Landcruiser Ute

I want to change the engine oil in my 200 series cruiser how do I get to the sump plug & filter.

alicantecoli

Colin Stickland

  • 22516 Answers
  • Posted on Feb 22, 2013

SOURCE: airbag fuse on 2010 genesis coupe

Their isnt one ,if a fault refer to dealer ,these airbig things can and do cause serious injury if played around with and it goes off .

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

2010 Hilux, will lock its self 5 seconds after ute is turned off. Have locked keys in ute about 15 times this year

This is usually a problem with the master/control actuator, this is the drivers door actuator, will need to strip out and check for faults,
0helpful
1answer

Mahindra maxximo fold cod p1492 pickup problem oncar start 5minut bath pickup problem

that looks like a compa tibility issue
check the user manual if u have it or get one from https://www.reliable-store.com/
0helpful
1answer

What does B2511 and B1810 fault code means in a Mahindra XUV500?

B2511 is a either a "steering wheel control convenience key stuck" or "horn output relay circuit short to battery" (means a button on the steering wheel is jammed - also could be as a result of holding a button down for too long and the ECM has determined it has a fault even if it is still functioning properly). The next code is a bit more concerning as it could be reading as a "centre airbag error" on some ECM's, while others show a "lamp backup input circuit failure" (if there isn't an airbag error light on, I'd think it's the lamp backup). Try clearing the codes and then see which code reappears to confirm the error code fault.
0helpful
1answer

Can you unplug the ECU unit and plug in a new one without reprogramming?

not sure about that vehicle? but general rule is that its programmed to rest of the system by a computer network like CAN. if you change it. it will not work without reprogamming in to the system so my answer is prob no! what module is it?
0helpful
2answers

Location of airbag module on 2009 Ford Edge

where is the airbag controls module located on a 2010 ford edge
0helpful
2answers

Airbag control module on a 2010 jetta where is located

Hi. It is under the dash on top of the centre tunnel in the very front of the interior cabin. This needs to be coded when fitted. The battery must be disconnected during replacement. This is a very sensitive unit and should only be replaced by trained or experienced technicians. There is danger of injury as static can deploy the airbags if not worked on correctly!
1helpful
2answers
0helpful
1answer

Airbag module location for 2010 acura tl

Where is the airbag module located at in a 2010 Acura tl
Not finding what you are looking for?

129 views

Ask a Question

Usually answered in minutes!

Top Mahindra Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

old marine
old marine

Level 3 Expert

2426 Answers

Ngoro

Level 3 Expert

3521 Answers

Are you a Mahindra Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...