- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
There is a safety switch on the clutch pedal-it is called a clutch interlock switch. Unless the clutch is depressed (so the switch is on), the power won't pass from the key switch to the starter to start the car. Check your clutch safety switch. It will be up high on the pedal, or mounted close to the pedal so the pedal operation will actuate the switch. It may be defective, or it may have slipped out of position.
is there signal to the magnetic cluch? if so its the magnetic clutch not angaging it is cotroled by the switch the relay and the modual but if you have the signal and ground and the clutch isnt activating then the clutch is bad it also has sensors that will deactivate it if there is a problem
I believe there is a switch on a lot of manual trans cars on the floorboard.This ensures that the clutch pedal is all the way down before the starter is engaged.( I am taking a guess here)
Hello: Check all the fuses for the system, make sure the connector to the clutch coil is fastened correctly. Check the back of the a/c compressor and the accumulator for the switch.
Down by the clutch pedal, there is a safety switch that allows a signal to be sent to the starter relay. The switch probably has a bad spot inside that is not allowing a good contact. You will possibly need to replace or have the switch replaced.
The pressures of the refrigerant must be close or the system pressure sensors will not let the AC cluch pull in. AC is just not wise for DIY without some gauges and knowledge. Sorry.
×