Question about 2013 Dodge Avenger

Open Question

Full electrical wire harness

My wires got cut from the front passenger side of my avenger what is the parts true name also can i combined any copper wire to fill in the missing gaps

Posted by Jay Mendez on

Ad

5 Related Answers

okcfirewall

okcfirewall

  • 80 Answers

SOURCE: Cooling Fans electrical connector melted. Is it available?

you can get one off of a used car but your still going to have to cut the wires. I would just directly connect it and eliminate the plug altogether just make sure you don't mix the wires up and you shrink wrap or use black electrical tape to re-insulate the wires and keep them from shorting out. If it burned up or melted this would be a good time to reroute the wires to a different location so this will no longer be a problem. It should work fine and give you no problems if the fans are still good as you say I hope this helps please don't forget to rate

Posted on Jul 23, 2009

Ad

Anonymous

  • 52 Answers

SOURCE: Break Light wiring diagram for 1998 dodge ram 1500

haynes repair manual has a brake switch diagrame

Posted on Feb 15, 2010

Ad
AEpgh

AEpittsburgh

  • 70 Answers

SOURCE: My 2000 Durango electrical/wiring problems...

The power lock problem is definately the electric lock actuator in the door. Replace it.
The power window problem could be the switch or the motor.
Put a test light on the motor connections. Operate the power window switch up and down. If the light works both directions, then replace the motor. If the light only lights one direction, then replace the switch... and you still might have to replace the motor afterward so do not think that replacing the switch is absolute. They sometimes fail together.

Posted on Mar 21, 2010

Anonymous

  • 518 Answers

SOURCE: the three wires to the tow lights have been cut,

Yes. But do you have seperate yellow turn signal lights in the rear or do the turn signals work independant of the brake lights? If yes then you need to wire in a taillight converter. It takes your seperate left & right turn signals combines them with your brake lights on 2 wires instead of 3 leaving you with your normal 4 wires in total instead of 5. 1 Left turn & brake light. 1 Right turn & brake. 1 Taillight. 1 Ground. = 4 wires in total. If you dont have seperate rear turn signals just find left turn wire in taillight assembly, Right turn wire & Taillight & a good ground & you are done. On trailer plug yellow is left, green is right ,brown is tailight & white is ground.

Posted on Jun 06, 2010

ercupa190

ernesto cuadra

  • 12223 Answers

SOURCE: Electric door lock on 2007 Dodge Grand Caravan not working

see the diagram attached and think clearly and logically, NOT feared. test any connection continuity, fuses, see for corrosion, tes the switch for defective or dirty, and motor.,loose connector or connector God bless you
7_25_2012_8_33_58_am.gif

Posted on Jul 25, 2012

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Will a 2010 dodge avenger sxt right passenger side fender fit a 2008 Dodge avenger sxt model both are 4dr sedans


Ebay part. It will list all vehicles the fender will fit. Kind of a "reverse" interchange book, but it works.

Mar 11, 2015 | Dodge Avenger Cars & Trucks

1 Answer

I need to know what the part on the passenger side of the car grounded to the floor it's a cluster of wires that if not hooked up makes the abs lights,security lights, as well as the front blower moto


All the wires are black or black with a white stripe. These are all ground wires. In a plug. Cut the plug off. Strip the wires back. put them all in a ground lug. smash or solder them all together. reattach them to the body. Things will start working again. There is one one the passenger side and one on the drivers side.

Jan 04, 2015 | 2003 GMC Envoy Xl

3 Answers

(low coolant) light stays on , even though i fill it up. Could this be a problem, or a fuse?


More like the sensor in the radiator is bad or stuck. Try tapping on it. It is in the passenger side tank of the radiator.

Jan 13, 2011 | 1993 Chevrolet Lumina

1 Answer

Hi i have a 03 impala it started missing I took it and had the code read. The check engine lite was flashing not just on . It showed #5 cyclinder miss fireing so I changs the plugs and wires.The auto parts...


With out a diagram to show you this will be difficult to explain so bear with my explaination. Starting from the passenger side of the car reading to the drivers it is 6,3 2,5 4,1. Now for where the wires go. The spark plugs you can see( front) are 2, 4, 6 reading the same same way passenger to drivers side. The other side 1, 3, 5 reading from passenger side to drivers side. I hope this helps. You probably need a fuel injector to correct the original problem.

Feb 08, 2010 | 2003 Chevrolet Impala

2 Answers

I have a miss fire


Recheck the firing order; 1-6-5-4-3-2

On the distributor passenger side radiator to fire wall. 2-4-6-coil
On the distributor drivers side radiator to fire wall. 3-1-5

Cylinder passenger side radiator to fire wall. 2-4-6
Cylinder drivers side radiator to fire wall. 1-3-5

Good luck and also check the distributor cap again for proper seating.

Nov 13, 2009 | 1998 Chevrolet Blazer

1 Answer

I have a 1997 dodge avenger ..right headlight and quarter light don't turn on i checked every fuse they all work did miss something?


sounds like you have a broken wire or a bad ground. check to see if the wires to the front right are rubbing on a sharp edge or have gotten pinched.

Jul 18, 2009 | 1997 Dodge Avenger

1 Answer

A wire poked through the front passenger seat. I


it's a black enamel coated thick WIRE or a cable/electrical lead?
If it's a strong steel wire in black enamel it is most likely a part of the seat's reinforcement. Are there overweight passengers often sitting in there? Anyways I can't really imagine what tool could cut it nice plain enough -that's not the way! you could miss that "spare" part.
look underneath your seat from the back, use a pocket torch to light it up there. Then look underneath it from the front using a mirror and lighting the spot from the back passenger's footspace with a torch. If you don't have a handy little mirror, borrow one from a woman-they always have one.
you can pull it in from underneath the seat. You might need to remove the upholstery to get proper access though. 
If you're unsure, consider a visit at a Ford shop or an upholstery apecialist.

Apr 11, 2009 | 2000 Ford Expedition

1 Answer

I need a spark plug wiring diagram for a 1990 Ford Ranger 2.3L


auto parts stores should be able to tell you your firing order

Feb 26, 2009 | 1990 Ford Ranger SuperCab

1 Answer

I repair my Equinox 2007 under seat after that the passenger airbag is shown OFF ?? I havnt seen any problem before under seat repairing .


HIYA!
All Equinoxes has yellow coloured wire harness to identify this as a air-bag system.
This yellow coloured wire 'system network' has connections in some areas...one is located at the front passenger's floor area close to the door (right-side corner area, just remove screw or clip and plastic trim part to gain access to see yellow wire there-it has socket plug connected with red clip-string to secure it) and another yellow wire is found between the front seats-you need to remove armrest, center console area and possible remove the front passenger seat to see yellow wire connect to black device underneath carpet in the middle.
Check to ensure the yellow wire sockets are plugged in properly, and not accidently cut or pulled off during your underseat repair.
In case your Equinox has roof side air-bag option, the yellow wire/sensor are located below the front seatbelt device inside the lower pillar frame area. (it's between the doors)
Hope this help you solve your repair task.

Jan 11, 2009 | 2005 Chevrolet Equinox

4 Answers

Re: peugeot 306 engine not starting after being hit in the front bumper


how hard was your car hit?? is it petrol or diesel? if its petrol the first thing that pops to mind is that, under the bonnet near the back (cant remember what side) you'll see a big red button, press it and try agaijn.. this is a knock sensor for if you ever have a crash... ive set one off just by parking and bumpin the car in front

May 19, 2008 | 1987 Peugeot Liberte

Not finding what you are looking for?
2013 Dodge Avenger Logo

Related Topics:

33 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14852 Answers

Mike

Level 3 Expert

4372 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...