Question about 2008 Toyota Prius

Open Question

All Codes for prius 2008 - 2008 Toyota Prius

Posted by Ashneel Kumar on

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Can I fix fuel gauge sending unit on a toyota prius 2008?


You can replace and or fix it. Before you proceed make sure that there is no open or short circuit in the fuel gauge system.

Apr 02, 2015 | 2008 Toyota Prius

1 Answer

I have 2008 toyota prius whent i start tha car after 10 to 20 seconds turn of


This could be related to the alternator not working as the electric system fails. How does the car run? If it is rough then it could be engine trouble, otherwise alternator or electrical drain.

Feb 09, 2015 | 2008 Toyota Prius

2 Answers

What causes the prius to not rev up when gas pedal is pushed


can be a few things , i'd suggest getting the OBD codes read as will point you in the direction of the problem

Jul 20, 2014 | 2008 Toyota Prius

1 Answer

Fuse Box Toyota 2008 Prius Diagram


On this website (link below) you find fuse box diagram and description for Toyota Prius (2008)

Toyota Prius Second Generation XW20 2008 2009 fuse box diagram Auto Genius

And fuse box diagram and description for Ford Windstar (1997)

Ford Windstar 1996 fuse box diagram USA version Auto Genius

Jun 19, 2014 | 1997 Ford Windstar

1 Answer

My 2008 Toyota Prius has begun occassionally surging while going uphill in cruise control. It revs to full throttle then no throttle then back to full throttle then no throttle again. I had a Toyota dealer...


the cruise control limits have been exceeded
the rad speed drops going up hill, the transmission shifts , that exceeds the rpm so it drops back the gear s shift again and the cycle is repeated
nothing really wrong , just incorrect driving practice
good practice is to turn of the cruise control when going up hills that puts the control outside parameters for the operation

Nov 09, 2017 | 2008 Toyota Prius

1 Answer

Removal of 2008 Prius steering wheel -


with a small flat screwdriver, remove the 2 by 2 inch black plastic covers behind the steering wheel. one of them has a hole for the cruis control lever.
loosen but dont remove the two torx screws behind these covers.
allow the airbag to fall out into your hands.
carefully raise the two yellow retainers on the airbag wires, then pull the wires away from the airbag module.
then squeeze and pull the black horn wire from the airbag.
to replace the steering wheel, unplug all the wires you see and remove the 19mm nut holding the wheel.
then by hand wiggle the steering wheel toward you.

Mar 24, 2009 | 2008 Toyota Prius

2 Answers

Toyota 2008 Prius Touch-Screen


Problem is resolved, 
I pulled & giggled a couple of fuses, found one fuse that had an extend fuse container was probably not quite seated right. Will notify dealer & replace several working fuses with new. rr 

Mar 19, 2009 | 2008 Toyota Prius

Not finding what you are looking for?
2008 Toyota Prius Logo

Related Topics:

212 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...