SOURCE: 1999 Dodge Ram 1500 Fan Motor Resistor Location
I've never seen a vehicle w/o a blower resistor. You don't need to remove the blower. The resistor is about 2 inches x 3 inches and is installed in a hole in the plenum (duct) near the blower motor. It will have a wiring harness connected to it. It could be under the passenger dash or under the hood, depending on where the blower motor is.
SOURCE: Where is the blower resistor on a 2001 Nissan Sentra?
Its actually not that bad to change. If you open the glove box and remove the screws then the screws along the bottom of the glove box at the bottom of the dash the box will slide out. Remember to disconnect the light if it has one. Now you will be able to see the underside of the dash. You can see a large black box that has wires and vacuum lines all over. You need to locate a small flat plate with two screws and a plug in the middle. Disconnect the plug and remove the screws. The resistor will come straight out. The back side will look like small coiled up springs of different sizes. Install in reverse.Hope this helps. Good luck. Please re-post with updates. Thanks cj2176.
SOURCE: 95 volvo 850 blower problem
It is the resistor that is causing that.
It requires replacement, attempting to repair it is not advisable.
The resistor is bottom connector (h2) in the picture:
SOURCE: 1998 Ford Expedition Fan Blower Resistor Location
It should be located on the blower motor housing under the right side of the dash, it will have wiring connector and 2 screws holding it in.
SOURCE: 2005 Nissan Altima where is blower motor resistor
The blower motor resistor is mounted under the glove box. It is in the corner somewhat covered by the kick panel. The card, at least on my pathfinder, is held in with 2 phillips head screws. The plug has 4 wires, one large wire and 3 smaller wires. You should see it very near to and parallel with the firewall.
2,112 views
Usually answered in minutes!
×