SOURCE: where is the open door sensor?
i repaired my wifes car same fault.you need to remove the lock catch mechanism out of door(not door lock) it's tricky belive me 1st time.check how this is done or you could destroy window winder.glass .needs to come out ect.on the side of lock a micro switch operates lamp and buzzer. i cut it off and glued it tighter to lever works fine now.
SOURCE: Car won't crank & makes a clicking noise when ignition is turned.
Is this the original battery? Have u had it tested? The no crank, clicking noise is classic dead battery symptoms, lights can still work, but not enough power to turn engine over. If it's the original battery, it's at the end of it's life cycle, and should be replaced. U can get the battery tested for free at any parts store.
SOURCE: key is stuck
I had this problem too. You have to make sure on the shifter that the knob towards the dash is out. You know the one you hold in while you move the shifter into gear.
SOURCE: program instruction garage door opener in 2005 chrysler pacifica
if your garage motor have rolling codes you need to put your car inside garage near the motor leave ignition on go to the motor locate learn button press it then quickly go to the car and press and hold one of the buttons for approximately 30 sec or until it start blinking rapidly, if you have a regular motor take one hand held opener go inside car ignition on same time press open button on handheld remote and on the car button 30 sec and it should be programmed.
214 views
Usually answered in minutes!
×