You need to determine if it's the horn or the alarm. My Montero (not Sport) had 3 horns. All 3 of which go off w/ the Alarm, but only one is connected to the horn on the steering wheel. I could not make mine go off w/o pulling the relay under the hood.
My spring was bad in the steering wheel. I was able to bypass the wire using instructions that I actually found on a Mitsubishi Forum. Link below:
http://mitsubishiforum.com/forum/mitsubishi-montero-montero-sport-14/horn-wouldnt-stop-2003-montero-limited-how-i-fixed-37779/
or
http://www.pajero.guru/how-to-fix-pajero-stuck-horn-problem-step-by-step-guide/
SOURCE: Replace Spark Plugs on a Mitsubishi Montero Sport 2001
http://www.autozone.com/autozone/repairinfo/common/repairInfoMain.jsp?targetPage=productsHowToInspect&leftNavPage=productsHowTo&pageId=%090900c15280213e6e&subtitle=service
Try to copy and paste this web site. It's for Auto Zone. It will tell you all you need to know about your vehicle.
Good Luck and hope this helps.
SOURCE: mitsubishi horn doesn't work
in my 98 montero sport the horn relay is next to the power steering resivour. As you look at the engine far left side a little black square. Just changed mine cause it went out
SOURCE: How to change horn on 1998 montero sport
Just changed my horns on my 98 Montero Sport and come to find out it was the horn relay. The horn relay is located near your power steering resivour its a small black square you will see some electrical lines running to it. Give it a couple taps and then try out your horn again. If that dosnt work your horns are located right behind your turn signals on your front bumper, they are circluar 3in and golden colored. You can get dealer ship replacement horns for 30 plus dollars or go to a autozone or advance auto and get aftermarket ones
SOURCE: how do you tighten ac compr belt on mit montero sport xls 3.5?
on the engine between the a/c compressor and crank pulley is adjusting pulley its above both of them in the middle loosen the 14mm nut on front of the pulley and turn the 12mm adjusting bolt clockwise until the belt is tight but not too tight if it continues to squeal just replace the belt you do not have to take any other belts off to replace
SOURCE: where is the bank 2 sensor1 located in a xls
what?? bank 2 is the drivers side of the engine sensor 1 is located before the cat conv next to the frame by the trans bell housing very tight location but is possible to change need a o2 socket that looks like a line wrench but beware if its seized you will have to heat with a torch or you will rip the threads out of the pipe/cat
1,188 views
Usually answered in minutes!
×