Question about 1994 Acura Legend

Open Question

How to jack up a 1994 acura legend ? - 1994 Acura Legend

Posted by Denise jewell on

Ad

5 Related Answers

Anonymous

  • 2 Answers

SOURCE: Acura Legend Sedan 3.2 lts 1994

replace de ignition module first.. if still wont start good chances is the crank sensor is located behind the timing belt.. my 94 legend use to do the same thing until i replace the crank sensor.. and also if u can afford i will suggest u to replace the main fuel relay too... all this is after u are 100 pcnt sure that ur fuel pump is working....

Posted on Oct 09, 2008

Ad
freetek

Steve Allison

  • 5569 Answers

SOURCE: Acura Legend 1994 fires, but won't start

'Fires' implies that you have spark and fuel; I think you mean that it cranks with the starter. Checking these separately is not difficult, you need to remove one spark plug lead and insert a screwdriver, then position the wire and the 'extension' so that the shank of the screwdriver is close to, but not touching some metal related to ground. This is about any exposed metal on the engine. When cranking, during each revolution you should see a healthy blue spark between 1/4" to as much as an inch. This tells you that the system supplying the high voltage is at least working. Of course that alone doesn't tell you that each plug is getting spark but to do that, you would need to remove each plug wire from the plug in succession and test them individually. Generally, if you have a single failed plug wire or plug, the engine will start but miss noticeably and it isn't not likely that all plugs and wires fail at the same time.
Checking the fuel supply depends a little on the delivery system. I think your car does have fuel injection so look for a fuel 'rail' that runs parallel to the engine. This is a length of pipe to which the injectors are attached and delivers gas to them. Most of the fuel rails will have a pressure relief valve on them that looks similar to a tire valve. After cranking for a few seconds, depressing the center pin should result in gasoline squirting from it. If it doesn't, you may have a failed fuel pump or a severely clogged inline filter. A bad fuel pump is more likely.
There are other points of failure such as a defective ignition switch but these will not normally fail instantly but become unreliable first.
When a recently run engine refuses to start, it is sometimes due to too much fuel in the cylinders (flooding) and this can cause plugs to fail to fire and can be alleviated by depressing the accelerator pedal completely to the floor and leaving it there; don't pump. This causes more air to enter the engine without causing additional fuel to flow and will, after cranking for 30-60 seconds, dry the plugs out and allow them to fire again.

The fuel pump in your car may be fused so I would check the fuse box for any visibly blown fuses too.

Posted on Nov 17, 2008

Ad
dlongav

David Quesenberry

  • 98 Answers

SOURCE: I need unlock code for 1994 acura legend with bose radio serial n

What you need to do is pull your radio and get serial number and model number. If you call the dealer with this info and can prove you are owner they will give you the code usually for free.. If you go to dealer and they take it out they will charge you around $90...You might get lucky sometimes the dealership puts the sticker on the door jam by the mfr sticker itr is a 5 digit code... Good Luck

Posted on Jan 02, 2009

Anonymous

  • 104 Answers

SOURCE: how to remove starter from 1991 acura legend

Follow the battery wire (disconnected) to the starter and remove the nut and solenoid wire. There should be two bolts to the bellhousing (a old term for the transmission to engine piece).

Posted on Sep 09, 2009

fingaz22

michael schultz

  • 1068 Answers

SOURCE: 1994 Acura Legend check engine light is on. When

turn the ignition key to the acc or lock position with the odometer reading showing.

while holding the trip/reset button turn the ignition to the on position. light should flash and go out!

reset done. if you have any more issues plese ask. good luck

Posted on Sep 25, 2009

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1994 Acura Legend LS 6-spd. Idle Surging RPMs High & Low and doesn't stop after starting. Continues to do it at each stopping point?


you have air in your coolant. This is a common problem that causes surging idle on the Legends. You need to bleed the cooling system. Have a read here
http://www.acura-legend.com/vbulletin/f4/help-bleeding-cooling-system-142866/

Dec 10, 2016 | 1994 Acura Legend

1 Answer

Why wont my 1994 acura legend car door open right after changing tire ?


possible jacked the car in the wrong place and the door sill has bent up into the door opening
take it to a panel repair shop for a proper diagnosis of the problem

Sep 18, 2016 | 1994 Acura Legend

1 Answer

Where is fuel pump relay on acura legend 89 i dont know if i need a fuel pump or fuel filter


where is the fuel pump located on my 1994 acura legend and how to check the relay and where is it located

Oct 01, 2010 | 1993 Acura Legend

1 Answer

How do i bleed coolant system on 1994 acura legend?


USE THE GENERIC METHOD BELOW WORKS FOR ANY CAR.
The generic method of bleeding air from the cooling system is to use a floor jack and raise the front of the car as high as poss, then fill the coolant recovery tank full and run the engine until it just starts to overheat, high end of normal zone on gauge, then shut the engine down and run cold water over the radiator core, this will self bleed the system and the coolant will be pulled from the recovery tank, repeat as necessary, never let the recovery tank run dry or more air will be pulled into the cooling systeml

May 19, 2010 | 1994 Acura Legend

1 Answer

1994 Acura Legend check engine light is on. When


turn the ignition key to the acc or lock position with the odometer reading showing.

while holding the trip/reset button turn the ignition to the on position. light should flash and go out!

reset done. if you have any more issues plese ask. good luck

Sep 25, 2009 | 1992 Acura Legend

1 Answer

Where is plug for check engine light? 1994 acura Legend


IT IS LOCATED BEHIND THE GLOVEBOX. JUMP THE CONNECTOR AND COUNT THE FLASHES OF THE CHECK ENGINE LIGHT. HOPE THIS HELPS, LET ME KNOW. BEST OF LUCK TO YOU.

Apr 29, 2009 | 1994 Acura Legend

1 Answer

Need the security code for my radio


contact Acura Dealer and give VIN- I had a bose premium system san scenario ( STOCK) and my code 5 digits (may be universal)

Apr 04, 2009 | 1994 Acura Legend

2 Answers

Car ill not start


you need the electrical part of the ignition switch this is a common problem on this model.

Mar 21, 2009 | 1994 Acura Legend

1 Answer

Acura Legend Sedan 3.2 lts 1994


replace de ignition module first.. if still wont start good chances is the crank sensor is located behind the timing belt.. my 94 legend use to do the same thing until i replace the crank sensor.. and also if u can afford i will suggest u to replace the main fuel relay too... all this is after u are 100 pcnt sure that ur fuel pump is working....

Sep 26, 2008 | 1994 Acura Legend

6 Answers

1994 ACURA LEGEND RADIO CODE


i have a 1994 acura ledgend but i dont have the owners manuel that holds the code. how can i bypass or get it to work

Jul 10, 2008 | 1994 Acura Legend

Not finding what you are looking for?
1994 Acura Legend Logo

Related Topics:

82 people viewed this question

Ask a Question

Usually answered in minutes!

Top Acura Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you an Acura Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...