Fuse Box Diagram Buick LeSabre (2000-2005)
https://fuse-box.info > buick > buick-lesabre-2000-200...
Here you will find fuse box diagrams of Buick LeSabre 2000, 2001, 2002, 2003, 2004 and 2005, get information about the location of the fuse panels inside ...
Buick LeSabre (2000 - 2002) - fuse box diagram - Auto Genius
https://www.autogenius.info > buick-lesabre-2000-2002...
Jan 22, 2017 - The engine compartment fuse block is located near the front on the passenger's side of the vehicle. Buick LeSabre - fuse box - engine ...
PWR WDO - 30amp circuit breaker , DRV -MDL 10amp fuse - both are located in the rear fuse box .
Fuse Block Rear
Under the left side of the rear passenger compartment seat
To locate fuses by part number on a 2002 Buick LaCrosse, look under "Passenger Interior Fuses & Circuit Protection" in the "Sissy Bar" compartment.
SOURCE: Interior lights won't turn off 1999 BuicK LeSabre.
yes there is a relay switch in engine compartment or under dash
SOURCE: fuse location
There is not a fuse listed for heated seats but fuse 16 is for heated mirrors and fuse 11 is power seats. i'm guessing one of those should also control the heated seats.
SOURCE: 2002 Buick Lesabre drivers side window went down,
A couple of things to add to tinyp's solution. For Buicks, the regulator is bolted in, not riveted, which makes removal easier. Also, you'd better get used to this, as I have replaced 3 out of 4 window regulators on my 2002 LeSabre.
SOURCE: 99 Buick LeSabre, how do I remove driver side door panel to replace power window motor?
You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door
SOURCE: 94 LeSabre inner door panel removal
On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls
694 views
Usually answered in minutes!
×