How to reset run flat warning on bmw x1 2011 model sdrive

A kick in what way, trying to kick to one side or the other, trying to kick forward or backward, kick like jerking gear change??

No you dont need to reset anything,you replaced the headgasket,what is the warning light that you are getting.

dealer only diagnostic equipment ,or take the bulb out

It warns you that something in the engine or within the car needs attention. The warning light is usually yellow in color. Example: low gas warning-light. It will stay 'on' till the problem is fixed. You could sdrive the car, but be aware, be warned!

If a red light comes 'on', it indicates something improper has happened, needing immediate attention. An example is a door that was not fully closed. This red-light also will stay 'on' till the problem is fixed.

i have a bmw , 1 series, i have just put air in my tyres and there is now a warning light on the dashboard, have i over inflated my tyres?

This will only come on when a tyre has dropped in pressure (not spare). It work on the principle that a tyre with less air has a smaller rolling circumference and therefore a different wheel speed. This is then monitored against other signals from other wheels and determined that a loss in pressure has occured.

If all tyre pressures seem ok, there could be a chance of a small unoticeable leak and would require a bath test. This is when the tyre is dipped in water and bubbles would appear where the puncture is.

Ultimately the system may just need to be reset, or has incorrectly been reset from a tyre change. For this you just press and hold the TPC button (located on the centre console above the gearstick - looks like a flat tyre with an exclamation) turn on the ignition to position 2 and the light will come on re then yellow,go out, come back on yellow. When it comes back on yellow it re-initializing the system. You can let go of the button and after 20 odd seconds the light will go out for the final time, completing the reset.

If the light continues to come on after the reset then you definitely have a puncture somewhere!

Hope this helps!

use the I drive system to reset flat tire monitor, go to vehicle settings, then flat tire monitor, then select reset, then you have to drive the car system resets as you drive

Using the indicator stalk, navigate to the tyre pressure reset option, press the reset button twice in short succession but hold it in the second time until a tick appears on the display

the brake pad warning light is controlled by a sensor located in the front and rear brake pads, small contact with 2 wires that plud into a harness, if they are bad I think the replacement cost is around 5-10 dollars for a new one, there will only be one in the front and one in the rear, the service light is turned out by a special tool at the dealer

I dunno if this will work on your BMW, but on my BMW Z3 and M3, it was....

Turn the ignition key to position 2, but do NOT start the car. Wait for about 45 seconds and the brake warning message will be reset.