1995 Mazda MPV Logo

Related Topics:

What happens if u cant get the rusty freeze plug out of or 1995 mazda mpv

5 Related Answers

A

Anonymous

  • Posted on Sep 28, 2008

SOURCE: oil change

It's a regular 12mm bolt (it doesn't look like a "plug") protruding horizontally from the back corner of the oil pan (aluminum pan with a waffle pattern, pretty much centered just in front of the front axle).

Ad

WDEMON

  • 2 Answers
  • Posted on Dec 02, 2008

SOURCE: Where is the starter on a 1995 Mazda MPV van?

it is located under the skid plate. you'll need to remove the front drive, the alternator, and power steering pump out to remove the starter. need to remove the bottom cover to see it.

Anonymous

  • 2 Answers
  • Posted on Jan 08, 2009

SOURCE: mazd mpv cranks sometimes starts sometimes nothing

I would check the ignition control module. It may be firing and missing intermitinly

emissionwiz

Marvin

  • 85242 Answers
  • Posted on May 19, 2009

SOURCE: Can't Find the spark plugs

pull of the engine covers if so equipped, the plugs each have there own ignition coil, they are held in position by a single retainer, remove the coils to access the plugs. see photo of coil

ad6fa2d.jpg

Anonymous

  • 1 Answer
  • Posted on Apr 15, 2011

SOURCE: HOW TO REPLACE 2001 MAZDA MPV SPARKPLUGS? PLEASE


All information is here: http://forum.mpvclub.com/viewtopic.php?t=25522

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2005 Mazda MPV V6. I cant find the OBD2 port under the driver dash.

Question edited for a lot more clarity and toss in a LOAD of Caps
Question moved to model category.

Mazda Mpv LW5W OBD schematic from 17 pin to OBD2 16 ...

Mazda Forum https://www.mazdaforum.com > ... > Mazda MPV
Aug 7, 2015 - My Mpv has a 16 pin socket under the left side of the dash, kind of pointing down. The plug in you are looking at is for Mazda dealer ...

Diagnostic Connector Type Question - Mazda Forum
Nov 23, 2007
Where is OBD connector - '06 Mazda 6
Aug 29, 2010
OBD II Not Communicating - Mazda Forum
Dec 26, 2008
Location to perform an engine Diagnostic - Mazda Forum
Nov 20, 2007
More results from www.mazdaforum.com

SOLVED: Mazda mpv obd2 connector location

Fixya https://www.fixya.com > ... > MPV > 1998 Mazda MPV
Your ground wire connection for the OBD2 connector is located under the dash just below and to the right of the heater controls. More likely that you dont have ...
..
0helpful
1answer

1996 mazda mpv 3.0 repair manuel. I need to replace a freeze plug and would like to locate them.Can I see a chilton repair manual?

If you go to this web site it will have pictures of the location and how to replace it
www.autocross.com/Replacing_a_freeze_plug/ccr200704011/1
3helpful
2answers

Is there a freeze plug in the back of the block on a mazda mpv 3.0 liter engine?

do mean a frost plug not to sure bout that whats the year of your car it will most probs be a alloy pipe or metal pipe that runs under your manifold they tend to corrode a bit sometimes stopleak works but if hole is to big you will have to replace it hope this helps ya
0helpful
1answer

Where is the core plug or freeze plug on a 1993 mazda mpv

They run along bolth sides of the engine block about mid way up on the bolck There not that to replace just sometimes hard to get at with the engine in the vehicle it depends witch one is leaking
1helpful
1answer

I have a 1995 Mazda MPV,V6,4x4,I think the fuel is not working

Don't drop the gas tank. Pull back the carpet in front of the rear seat and there will be a square cover closer to behind the passenger seat with 4 screws holding it down. Remove that cover and it will expose your fuel sending unit cover. This will be circular in shape with 6 or 8 small philips head screws holding it in place. Unfortunately they will probably be very rusty and hard to get out. You will first need to disconnect the electrical plug and the 2 fuel lines. After removal of the fuel lines and the screws carefully remove unit to expose fuel pump.
2helpful
1answer

Mazda MPV 1995 , over heat quickly

Your cooling fan(the electric fan in front of the radiator) is either damaged or not spinning. Don't drive it, until you get it repaired, or you
will seriously damage the engine.Good luck.
4helpful
1answer

How to change a timeing belt

Click on the following free direct Link. It has the Timing: Belt and Mark Diagrams for your 1995 Mazda MPV. Plus additional Instructional and Directional Diagrams.

Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!

http://www.2carpros.com/car_repair_information/year/1995/make/mazda/model/mpv/1995_mazda_mpv_timing_belt_diagram_marks.htm
1helpful
2answers

I have a 2003 Mazda MPV , the problem only happen

I ahve same issue with my 2004 MPV. I replaced the plugs, coils etc. No help.

did you ever get it fixed?
3helpful
2answers

2000 Mazda MPV Heating problem

The heater lines that run to the back of the right rear side gets rusty and start to leak anti-freeze. There is a black cover under and above the RR tire that has to be removed so u can see.
4helpful
1answer

Where is the starter on a 1995 Mazda MPV van?

it is located under the skid plate. you'll need to remove the front drive, the alternator, and power steering pump out to remove the starter. need to remove the bottom cover to see it.
Not finding what you are looking for?

68 views

Ask a Question

Usually answered in minutes!

Top Mazda Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...