Cars & Trucks Logo

Related Topics:

P
P Botha Posted on Jul 30, 2016

Mazda mx6 1997 model v6 auto,the car starts ok and idle smooth but it's got no refs. when on drive it's cuts on 2000 refs. What can cause this problem?

  • P Botha
    P Botha Jul 31, 2016

    Thanks Donald

    Can you please help with the location of this idle sensor?

×

1 Answer

Donald Laurie Thunder

Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

Hot-Shot:

An expert who has answered 20 questions.

Corporal:

An expert that has over 10 points.

  • Contributor 34 Answers
  • Posted on Jul 30, 2016
Donald Laurie Thunder
Contributor
Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

Hot-Shot:

An expert who has answered 20 questions.

Corporal:

An expert that has over 10 points.

Joined: Dec 31, 2008
Answers
34
Questions
1
Helped
5420
Points
56

Check your idle sensor, Mazda and fords have the same problem..hope this helps..

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

I have a Mazda MPV 2003, i bought from japan, 7 months ago, this van was running well until two days ago, it stsrts and cut off, starts again and while driving it is losing power then it will speed up

Before any diagnostics, I would run a tank of gas with a bottle of fuel dryer and injector cleaner to ensure that the engine racing isn't resulting from moisture and clogged injectors.
0helpful
1answer

Ford v6

First, do a tune-up. Make sure your air filter is clean and the idle air passages in the carburetor are clear. I assume at one the idle mixture was properly set, so if it's no longer idling properly, something else has changed. Fouled plugs or bad fuel could be a cause. In particular, ethanol-blend fuel that has been in the tank for several months will not work well in engines without electronic controls.
0helpful
2answers

2004 mazda 3 starts but will not idle stalls under 2000 rpm

You need to plug it in to an engine diagnostic computer, it is probably a sensor that needs to be replaced. (Coolant temperature sensor is a probable cause) but you should plug in to engine diagnostic computer.

If you need further help, reach me via phone at https://www.6ya.com/expert/frankie_091f536560a54e12

0helpful
2answers

1999 mazda 626 lx engine stalls when put in any gear

It can be low fuel pressure issue or clogged fuel pump. Or its engine related issues,---------------
Check the help link mentioned below to troubleshoot the problem: ------

Engine stalls, car stalls while starting, vehicle stalls while starting, Engine stalls and dies, Car stalls and stops,
http://alltypesofpartsreplacing.blogspot.com/2012/12/engine-stallscar-stalls-while.html

------
These will help.
Thanks.

0helpful
1answer

My 2000 mazda 626 v6 idles up and down but at low idle the oil light flickers on and off. i replaced the mass air flow sensor and proble is still there. when put it in park it idles high.

Most of the time when the cars idle fluctates up and down ia the IAC (idle air control) they either build up carbon and are slow to move of it is defective.
1helpful
1answer

Rover 75 v6 starts no problem runs 1000 rpm then

check idle speed sensor on your intake manifold around 700 to 750 rpm is normal ,air temp may efect idle speed .
0helpful
1answer

When starting from cold car runs ok for few seconds then hunts/missfire can cuts out.re starts ok but will do the same again ubtill you get a bit of heat into engine then its ok!

i advice you to change the spark plugs,this is cause because at cold start the engine needs a rich mixture in order to maintain a smooth idle,before driving the car,when starting from cold ,what you have to do is to accelerate up to 2000 rpm for 3 minutes then you drive it,then it should be ok
0helpful
1answer

Speedo will cut out when driving

Sounds like your "speed sensor" is failing. When it fails it will cause irregular shift patterns and engine idle speeds.
0helpful
1answer

MY 1993 MAZDA 929 WILL NOT IDLE

I, feel sorry for you, after reading your problem, but don't worry you visit the Reliable-Store they will help you for sure. 1993 MAZDA
8helpful
2answers

3.0 jaguar s type wont idle

Check breather pipes, common thing on the jags, dragging oil residue and bad air into throttle, look for oil residue on engine.Good luck Davelee
Not finding what you are looking for?

89 views

Ask a Question

Usually answered in minutes!

Top Mazda Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...