Question about 2006 Kia Sportage

Open Question

Where do you find the blower motor resistor on the 2006 Kia Sportage. Please.

Posted by Kenna Mulligan on

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Location 2002 kia sportage blower motor resistor

Sorry I can't say precisely where it is. Blower motor resistors get hot and so they are usually positioned close to the motor and placed where they receive a strong flow of cooling air. Sometimes they are made easily accessible and sometimes quite a bit of dismantling is needed and sometimes contortions are needed when the resistor is buried under the dash.
0helpful
1answer

Where do I find the blower motor resistor on a 2006 kia sportage?

Hi Kathy,here's a link to where your blower motor is,in the pic,the dark part is your blower motor resistor,just remove electrical connector and 2 screws holding it on,very easy. Repair Guides Blower Motor Removal Installation AutoZone com Here's a pic of your resistor. Blower Motor Resistor at AutoZone com Best Blower Motor Resistor Parts for... Don't disconnect your negative battery terminal,will cause problems.
0helpful
1answer

Where is the resistor located on a 2006 kia sportage?

There are up to 1000 resistors in your car. Almost all are in the computers. So I assume your re talking about the one that isn't. It is on the passenger side behind the blower motor, under the dash.
0helpful
1answer
0helpful
2answers

Dead Fan blower 2006 Kia Sportage has 12v power, should I replace it?

Could be your blower motor resistor,it's mounted next to the blower motor,Autozone will take part back for refund if it don't fix problem.Here's what it looks like,Here's where the blower motor is.Easy to remove,disconnect electrical connector,remove 2 screws,can't look at it to tell if bad.Here's the relay.
2helpful
1answer

Sorry its blower


Its faulty blower motor resistor. The low and medium speed on blower motor is controlled by resistor and its actual speed is high. So because resistor is not working, blower motors actual speed which is high is working.


It can be faulty blower motor or faulty blower motor resistor. Get the blower motor inspected. If it's faulty it has to be replaced.


=======

For blower motor testing and replacing, check the link below: ----

Blower motor Testing/replacing for all vehicles?

http://repairhelpcenter.blogspot.in/2012/02/blower-motor-replacing-for-all-vehicles.html

------------

These will help.

Thanks.

4helpful
1answer

Heater blower motor.,Highspeed only works..problem??

9 out of 10 times its the heater fan resistor doing this. it has wires that corresponed to diffreent speed settings for heater fan. the resistor is beside the blower motor, Your Kia Sportage Blower Motor Resistor controls the heating equipment in the vehicle by opening and closing the fan motor. The Kia Sportage Blower Motor Resistor allows the heating and climate control system to control the speed of the vehicle's cooling fan. its under the passenger side glove box. undo 2 screws and disconnect the electrical connector. thats it!!
8helpful
1answer

Replaced blower motor in my 2001 kia sportage ex, fan only works on high. Any suggestions?

It could be the blower motor resistor, the high position feeds full 12 volt power directly to the blower motor. All lower settings route through the blower motor resistor. It is usually located under the passenger side dash, not far from the blower motor. Two screws secure it to the heater box.
4helpful
2answers

My 2006 Kia sportage blower motor quit. 40 amp fuse is OK. Thoughts on what else this can be?

Locate the motor, check if it is getting voltage when you turn it on, by probing the connectors. Another possiblity besides the motor is the motor control which control its speed. Newer cars usually have an electronic package located by the motor housing. It has a thermal fuse, that sometimes look like a resistor, that blows. and it looks like part of the circuit. Soldering tool is required to replace that. You can also check the motor by hot wiring it, but make sure it is disconnected, and isolated before performing the test. Otherwise you could fry up some electronic device.
Not finding what you are looking for?
2006 Kia Sportage Logo

Related Topics:

133 views

Ask a Question

Usually answered in minutes!

Top Kia Experts

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6963 Answers

Brad Brown

Level 3 Expert

18852 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15000 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...