Rear window will not close

Rear Passenger Power Window Operation
The rear passenger power window switches receive battery voltage through the window lockout control circuit if the window lockout function is disabled. Ground for the rear passenger power window motors is supplied through normally closed up and down contacts of both the rear passenger power window switches and the driver power window switch. When the either rear passenger power window switch is placed in the down position, the power window motor down control circuit is switched to 12 volts and is applied to the down side of the rear passenger power window motor. Since the other side of the rear passenger power motor is connected to ground through the normally closed up contacts of both the rear passenger and driver power window switches, the window travels down. By placing the rear passenger power window switch in the up position, the polarity of the power window motor is reversed and the window travels up.
The rear passenger power windows can also be controlled from the driver power window switch.

Did you try pushing the lock out switch on the drivers master switch ?

Will your master switch work? If not check out electrical connections/power to affected unit.

Is the safty switch ingaged. Some switches are on the drivers side window and door lock control panel and sometimes its on the end of the door itself so it's not accessible from inside the car.

Either the master switch or a partial open in the wires in the hinge area.

Then you found it also the window lock switch can also affect it use this diagram to help you you have a control switch on the driver side problem

It sounds like you have a switch problem in your door panel.if you can raise the window in the rear with the switch but not from the front then suspect the switch in your drivers door panel. If neither window will open with the switch in either door panel, still check your drivers door panel switch.you may try running power to the motor by itself with a jumper wire from a known 12v lead from the battery if you can and see if the windows will raise and lower without using the switch.

The problem is that you probably have pushe dhte rear window button thinking it wasthe front window button. Have you ever pushed the rear window button thinking it was the front and then push harder. Inside the switch ther are little plastic pins. Open the switch and turn the little pns around and you should e fine. you cna e-mail me if you like and I can tell youhow to fix [email protected]

Hi! You may want to start spraying contact cleaners on the control switches. If these switches are seldomly used this issues happens. Try it and see how it goes. Hope this helps and thank you for using FixYa!

replace the switch. They have parts made of plastic pressing on the contacts softing these babies up making them useless in a few years

There is a button on the master switch (drivers) to turn off the rear windows make sure it's not depressed. If not the master switch is probably bad since you lost both rear window control . Power and grounds to the rear switches comes from the master switch.