Question about 2003 Chevrolet Venture

1 Answer

Why did my lights quit coming on automatically on my 2003 chevy venture

Changed out signal lights on passenger side and now my headlights won't come on automatically

Posted by Delores Sherry on

Ad

1 Answer

steve

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 3,708 Answers

Have you made sure the connetor is pushed fully in and that you haven't knocked other connectors making them loose ? also check for the fuse for day time running lights your owners hand book will tell you which fuse it is

Posted on Jun 25, 2016

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2000 maxima...when headlights are on, passenger side blinker stays lit on the dash and doesn't flash at all. While the headlights are off and i turn the passenger turn signal on it then b


Plain and simple...Your turn signal circuit is shorted to your headlamp circuit. What USUALLY causes this is an incorrect light bulb has been installed in the vehicle or the light bulb was installed incorrectly. There are other possible causes of these circuits being shorted together, but 99 out of 100 of the times that I have seen this it is either because somebody just replaced a bulb or a bulb socket melted somwhere on the car. Be sure to check both the front AND rear bulbs.

Jan 07, 2012 | 2000 Nissan Maxima

1 Answer

Turn signal bulb was working, now it isnt


its is not uncommon for the contacts in the sockets to become corroded or just expand to the point of where they do not contact the bulb,try to test the socket with a multimeter for voltage,if it has voltage then its most likely the contacts,which sometimes can be rebent,but replaceing the sockets is a better solution,and can be picked up at most stores or 4x4 shops and junk yards.

Dec 14, 2011 | 1998 Jeep Cherokee

2 Answers

How do you replace the front turn signal on a 2005 Buick Terraza?


Changing front, right turn signal on 2005 Buick Terraza: Open hood; when facing the front of vehicle, the right turn signal is on the passenger side (left). The headlight assembly needs to be removed to easily reach the turn signal. On my vehicle, there is a 10 mm screw on the left side. Remove it. There is L-shaped pin on the right side of the headlight assembly. Swing the pin counter-clockwise (to the left). Pull the pin straight up to remove. The headlight assembly is now loose, but there is a pin snapped in a socket on the back of the assembly that still holds the assembly. Pull the headlight assembly hard and straight to the front of the vehicle. When it snaps loose, the assembly is now held just by the rubber gasket surrounding the assembly. You need to gently work the right side of the gasket out of the grill cowling. The assembly should pull straight out. The wires are long enough to lay the headlight assembly in the engine compartment. Finally, the turn signal is now accessible. Twist the light holder counter-clockwise and pull out the light holder. Change the bulb. Do not punch your man-card for credit until you have successfully reinstalled the headlight assembly. It goes back in a little easier the second time. Once you have put the L-pin in place, the screw back, and successfully tested the lights, you can now punch your man-card.

I give the mechanical engineers and designers a D-minus instead of an F only because I was successful on the first try. No light bulb on anything commonly used by people should be this hard to figure out.

Sep 07, 2010 | 2005 Buick Terraza

2 Answers

Need to change the passenger side headlight


This video will show you how to change the headlight in your Accord.">

May 19, 2010 | 1996 Honda Accord

1 Answer

Change turn signal bulbs,passenger side


big spring that clips onto the back of the headlight is i remember rightly

Mar 31, 2009 | 2000 Audi A6

1 Answer

How do you get to the front passenger blinker to change


on the 2004 grand cherokee, you have to remove the bolt that hold the light in. if you open the hood and look at the headlight, there is a bolt that go all of the way through the headlight, remove it and gently pull out on the whole assembly.

Dec 17, 2008 | 2004 Jeep Grand Cherokee

Not finding what you are looking for?
2003 Chevrolet Venture Logo

Related Topics:

64 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...