Question about 1993 Nissan Maxima

Open Question

93 Nissan Maxima GXE Revs up fine but boggs and wont go at all when you put it in D?Replaced the TPS and throttle body as well as the down pipe, gives a code for the TPS, Any ideas?

Posted by Tim Smith on

Ad

5 Related Answers

Anonymous

  • 1 Answer

SOURCE: CAR WONT START 1995 NISSAN MAXIMA GXE V6 REPLACED

it might be in your ignition still try turning it from the first click acc to stat and dont stop on the on position thats how mine is

Posted on Feb 23, 2010

Ad

Anonymous

  • 1 Answer

SOURCE: Speed sensor location on a Nissan Maxima 2000 GXE...

There are two speed sensors one is called a revolution sensor that is located on the case of the transmission. You can take the driver side wheel off and see the sensor on the top of the case of the transmission. A 10mm bolt is holding it in. Easy fix

Posted on Jun 17, 2010

Ad

Anonymous

  • 3 Answers

SOURCE: 96 Nissan Maxima continues to have engine light

I had a similar problem - took it into 'Nissan Professionals' and they changed everything you did as well, and had no luck. After 4 or 5 times working on it, they told me that it was a 'loose wire' that had to be re-soddered and then the problem was fixed. I don't know where the wire was, but they made it sound like it was in or around the fuse panel under the hood.
I hope this might shed some light on the problem.

Posted on Sep 14, 2010

saailer

David Burbee

  • 1871 Answers

SOURCE: I got a 86 Nissan 720 4x4 it got a tbi that is

Hello! It can be done but it requires quit a bit of work and expense...You'll need a source for spark, intake manifold, a mechanical fuel pump, or a method to reduce fuel pressure to 7 PSI...It's not just a simple bolt on...You mentioned the TPS....If this is the only fault (plus carbon build-up in the throttle body)...I will fix the throttle body for you...Best way to go...If you have a volt meter and a little experience using it I'll send a test procedure and walk you through it...Send a comment....Guru...Saailer

I’m happy to help further over the phone at https://www.6ya.com/expert/david_6df67de3b14de867

Posted on Oct 02, 2011

redds55

Ricky Peters

  • 2620 Answers

SOURCE: 98 Nissan Maxima Have replaced plugs, mass air flow sensor, cleaned throttle body, adjusted TPS and car still stalls at stop lights, have to put in neutral so it won't die. I can have the vehicle

The EGR Valve is either stopped up with carbon or it is justed worn out.More than likely there's carbon stopping air flow.You can try cleaning it with a non-chlronated brake cleaner and a scraper or wire brush.Reset the computer.

Posted on Jan 31, 2012

Testimonial: "Thanks for your assistance "

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

I have a Ford F150 XL with a 4.6 W engine the floor got washed and now it boggs down on acceleration it is a 2009.I have replaced the acceleraton pedal and throttle body but still boggs down

Needs to go on a scanner. Throttle bodies have to be reset to the computer. No programming, just a relearn/procedure. I knew it was a bad idea to put the TPS on the gas pedal. Nothing under the dash is weather packed.
0helpful
1answer

My 91 Nissan Maxima when idling in park or nuetral revs up and down. Then when it is in gear it revs up high like I am pushing on the gas. I have changed the throttle position sensor and that did not fix...

Check for any air leaks between the mass airflow meter and the engine like the rubber being split on the air intake boots etc.. I once had a toyota that would do the same thing and the fix for that was to flush the coolant passages in the throttle body, worth a try. Also you said you replaced the TPS. If the TPS has slotted holes you must set the minimum TPS volts or that can also cause idling issues. Clean the throttle body as well.
2helpful
1answer

98 Nissan Maxima Have replaced plugs, mass air flow sensor, cleaned throttle body, adjusted TPS and car still stalls at stop lights, have to put in neutral so it won't die. I can have the vehicle

The EGR Valve is either stopped up with carbon or it is justed worn out.More than likely there's carbon stopping air flow.You can try cleaning it with a non-chlronated brake cleaner and a scraper or wire brush.Reset the computer.
1helpful
1answer

Engine idles fine but when throttle is pressed it boggs down and stays down untill you depress the throttle. will not drive

Sounds like clogged catalytic converter. Remove the exhaust pipe from the manifold and try it. If it revs ok, you have a clog.
1helpful
1answer

2001 nissan maxima gle it bogs down when i press on the gas,idles low at .5 rpm,dies when i start it i have to keep my foot on the gas,lights run dim when i come to a full stop it has 155,000 miles

Hi and welcome to FixYa!

As a first course of action, I strongly suggest that you replace the MAF (mass air flow) sensor and the TPS (throttle position sensor). If the MAF and TPS is faulty the RPM tends to go down or goes erratic. The MAF and TPS is located at the throttle body which is secured by small screws or bolts. It is visible which can easily be seen.

Once replaced you'll be good. Hope this helps and thank you for using FixYa! Have a good one!
0helpful
2answers
1helpful
1answer

Nissan Maxima GXE '00 has occasional problems accelerating

PUT A MATCH IN THE GAS TANK THE NEXT TIME U FILL UP AND THEN RUN ABOUT 2 BLOCKS PROBLEM SOLVED
Not finding what you are looking for?
1993 Nissan Maxima Logo

Related Topics:

103 views

Ask a Question

Usually answered in minutes!

Top Nissan Experts

gerry bissi

Level 3 Expert

4390 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14942 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6928 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...