Where is the fuel pump relay - 2005 Mitsubishi Space Star

engine bay cluster
the cover has the legend

if fuel relay is ok ...could be this relay
Circuit Opening Relay
Circuit opening relay controls fuel pump circuit. The Engine Control Module (ECM) receives an input signal at STA terminal when engine is cranking. Starter signal is also applied to terminal STA of circuit opening relay.
Starter signal energizes circuit opening relay during cranking. Circuit opening relay then provides voltage to fuel pump or fuel pump relay.
Fuel pump switch in airflow meter provides ground for circuit opening relay.

Does vehicle start an run ? amp draw test the fuel pump , relay bad . Most vehicles the PCM controls the fuel pump relay . Just because relay is clicking does not mean fuel pump has a problem . Auto Repair How to Check Fuel Pump Relay Fuel Pump Electrical Circuits Description and Operation

Not guessing as to what the problem is , testing for voltage drop problems with a volt meter . posted a video on youtube yesterday . If your still looking for guesses forget it , no one on here could say for sure without testing the circuit an hooking up a scan tool to see if PCM is energizing the relay . Do yourself a favor an take it to a qualified repair shop . Fuel Pump Electrical Circuits Description and Operation If you can't learn how to test from this guy , better take to a repair shop .

it cuts the fuel off.

No noise from fuel pump when you turn over the car .First thing get voltage at fuel pump relay checked, is there 12 volt to the relay.If no, then problem is again the relay.--------- To reconfirm the problem, try other test, that is remove the relay and by pass the relay terminals with a jumper wire .Then with 12 volt external battery give power to fuel pump connector and see, if the fuel pump starts, then its clear that fuel pump relay is faulty.----------- Also other problem can be fuel pump inertia switch.If the inertia switch is faulty then also fuel pump will not start.-------- The fuel pump relay on a 1995 Ford Explorer is in the power distribution
box, in the engine compartment, driver's side near the firewall.----------
The fuel pump inertia switch is in the right front passenger area
it is below the dash but above the carpet in the right hand corner.--------
Its a push button type inertia switch.
--------
Fuel Pump Activation
When ignition switch is turned to START position, PCM operates fuel pump relay to provide fuel for starting engine. PCM senses engine speed and shuts off fuel pump by opening ground circuit to fuel pump relay when engine stops or engine speed drops to less than 120 RPM. When ignition switch is in ON position, EEC power relay is energized (contacts closed). Power is provided to fuel pump relay and timer in PCM. Fuel pump receives power through fuel pump relay contacts.
Inertia Fuel Shutoff (IFS) Switch
All models use an electrical interrupt switch in fuel system. During a collision or vehicle rollover, electrical contacts within inertia switch open, shutting off fuel supply to electric fuel pump. Fuel supply is interrupted even when engine is running.
A reset button is located on switch assembly. If electrical circuit trips, vehicle will not restart until switch is reset. Fuel system should be inspected before resetting switch.
IFS switch is located under instrument panel, near right side of transmission hump. ----------- If the fuel pump relay, the inertia switch and fuel pump all checked ok, and fuel pump is working with direct 12 volt source to fuel pump.Then problem relates to computer.The computer (power control module, PCM) is faulty and has to be replaced.--------- This will help.Thanks.Helpmech.

If fuel pump relay is bad yes it will still get spark.
Sonds like you do have a fuel pump, or fuel pump relay problem, most likely the pump.

The fuel pump relay is in the engine compartment fuse block at location K4/C-1051.

You could have a bad fuel pump relay switch. The fuel pump relay switch gets the fuel pump running in the vehicle during the start cycle. The terms fuel pump relay and fuel pump relay switch are used interchangeably. The fuel pump relay begins its job when the automobile operator turns to the ignition on, but before the motor is actually running. At that point, the fuel pump relay in some cars sends a signal to the ignition switch, which in turn sends a signal to the fuel pump to turn on. Others fuel pump relays have actual circuitry inside of them that receive the ignition signal and directly signal the fuel pump to engage.

Have a great day!

P0230 The power train control module (PCM) provides ignition positive voltage to the coil side of the fuel pump relay. When the ignition switch is first turned ON, the PCM energizes the fuel pump relay, which applies power to the fuel pump. The PCM enables the fuel pump relay as long as the engine is cranking or running, and crankshaft reference pulses are received. If no crankshaft reference pulses are received, the PCM de-energizes the fuel pump relay after 2 seconds. The PCM monitors the voltage on the fuel pump relay control circuit. If the PCM detects an incorrect voltage on the fuel pump relay control circuit, DTC P0230 sets.
Check the voltage of the battery, and check the fuel pump relay. You can try swapping the relay with another relay like the A/C relay for now and see if the check engine light (MIL) goes away. The control module turns OFF the malfunction indicator lamp (MIL) after 3 consecutive ignition cycles that the diagnostic runs and does not fail. Good luck and hope this helps. Keep me posted, be glad to help.

Hi irvj6ohn:
The 1993 and 1994 XJ6 Fuel Pump Relay is located in the trunk of the vehicle on the right hand rear side. It is light blue and black in color.
I hope this helps.

Regards
bobbyapal94