Question about GMC Cars & Trucks
IS the leak at the front
was the area all cleaned down after the work
looking at the youtube teardown
sump gasket , rocker cover gaskets
or rear engine seal
if its burning oil the valve stem seals and or piston rings
Posted on May 06, 2016
one, five, three, six, two, four
The plastic intake should have this sequence molded into it somewhere, and even the corresponding cylinder numbers in front of their respective holes. Have fun, and thanks for posting on Fixya.com
Posted on Mar 20, 2009
SOURCE: I need to know how
It would be to hard to tell and show you over the computer.
The best and easiest way for you is to buy a Chilton manual for your car at the autoparts store. The book runs about $20
This book is a do-it-yourself bible. It will show you everything you need to know on how to do maintenance and repair on your vehicle.
Posted on Apr 13, 2009
Try disconnecting the battery for a few minutes, that might get you out of trouble for now. There are some common problems with these 4wd systems. Most common is the mode position sensor on the encoder motor. Sometimes it can be the switch on the dash. Fact of the matter is I can't tell you what is wrong without using a scantool to retrieve the fault codes from the computer controlling the 4wd.
Posted on Oct 16, 2009
SOURCE: how to reset change oil
On a 2002 Envoy you turn the key to run but don't start it. Then push and release the gas pedal 3 times within 5 seconds. The change engine oil light should blink for 5 seconds meaning you have reset the system. If it doesn't blink for you do the procedure again.
Posted on Feb 08, 2011
Tips for a great answer:
Jul 23, 2016 | 2002 GMC Envoy
May 04, 2016 | Cars & Trucks
Apr 11, 2016 | GMC Cars & Trucks
Apr 01, 2015 | 2003 GMC Envoy
May 30, 2014 | 2002 GMC Envoy
Feb 09, 2011 | 2002 GMC Envoy
Feb 07, 2011 | GMC Jimmy Cars & Trucks
Feb 24, 2010 | 2002 GMC Envoy XL
Feb 05, 2010 | 2002 GMC Envoy
60 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: