Where is the signal flasher located - 1993 Buick LeSabre

The turn signal flasher on a 2014 Kia Sportage is typically located in the vehicle's fuse box. The exact location of the flasher will depend on the specific make and model of your Sportage, but it is generally located near the steering column or under the dashboard.
Here are the steps to locate the turn signal flasher:

1. Locate the fuse box: The fuse box in a Kia Sportage is typically located under the dashboard on the driver's side of the vehicle.
2. Identify the flasher: Once you have located the fuse box, look for the turn signal flasher, which is typically a small, rectangular box with two or three wires connected to it.
3. Test the flasher: Once you have found the flasher, you can test it by turning on the hazard lights and checking to see if the flasher is clicking. If it is not clicking, the flasher may be faulty and will need to be replaced.

Hello. It seems your vehicle has a 'shorting/malfunctioning turn signal switch and/or 'grounding' wires in the wiring harness. Good luck and keep me informed; if you want to.

Hazard and Turn Signal Flasher Replacement
Open the glove box to expose the glove box retaining tab (1). Lift the retaining tab and allow the glove box to hang freely.
Using a suitable flat-bladed tool, release the plastic retainer that retains the hazard/ turn signal flasher (1) to the C203 body harness connector (2) . Remove the hazard/ turn signal flasher (1).

The turn signal flasher and the emergency flasher on most cars are located in the same area. Turn on the emergency flasher and find the sound......the turn signal flasher should be in the same area.

located under dash to left of the steering colume. note there are 2 flasher relays one for the emergency flashers and the other is the signal flasher. to know which one is the signal one turn on the emergency lights and look for the flasher the one that is clicking is the e-flasher. the signal flasher looks the same locate it and replace.

usually the one flasher serves both turn signal & hazard flasher, if either one isn't working you may have other problems.....hope this helps.....cheers.

did both signal lights stop working at the same time or not,it may just be the signal flasher has gone bad,it is located under the dash by the fuse panel.if the hazard flashers work then i would say the signal flasher is bad.with the hazards on you can locate it and that is what the signal flasher looks like and it is a separate flasher,

There are 2 flasher relays. One for the turn signals and one for the hazard lights. Turn Signal Flasher is located on the driver's side, under dash, mounted on upper passenger side of steering column support. Hazard Flasher is located same place only it is mounted on the driver's side of the steering column.

I have a 94 Sonoma and to locate the turn signal flasher, inside, under dash, on left side is a plastic sound protector, mine had 3 screws holding it up, drop this down and straight in you will see a 1" round thing - this is the flasher.

here is the location of the flasher The Turn Signal and Hazard Warning Flasher is combined into one unit called a Combination Flasher (Combo-Flasher) The combo-flasher controls the flashing of the hazard warning system and the turn signal system. An inoperative bulb or incomplete turn signal circuit will result in an increase in flasher speed.
The combo-flasher is mounted to the in-line bracket which is located to the right of the Junction Block. The flasher can be removed by pulling in an rearward direction. The left under panel silencer duct must be removed to access the flasher. The combo-flasher is black in color for ease of identification