Have red engene lights at panel - 2008 Nissan Qashqai 1.5

run the fault codes to find the fault that put the light on

Pull up the error codes and post them here. Thanks.

take to a audi dealer could be something simple or worse i know there expensive but will give a definate diagnosis save you money in the long run

Have you checked your oil level? Is it over full on the dipstick? What does the oil look like - clear or milky? If milky, you may have had a head gasket failure or crack in the block/head that allowed coolant into the crankcase. If you kept running the engine after this, it may very well have seized. The timing chain can't get 'too tight', so that is not your problem.
Use a breaker bar with the appropriate sized socket and see if you can manually rotate the crankshaft pulley. If not, your engine is going to need some serious work (or replacement).

please you must need to pass the scanner for to detect if the bulb or some sensor is faulty. Is the best way. Otherwise your must waste your time. and mone.

God bless you

Make model and year, and have you had the computer scanned for trouble codes yet ?

To clarify, the check engine light should stay on until the engine starts.
Someone will need to figure out if you are lacking spark to the plugs, fuel to the injectors, or compression to proceed.

Check the oil in motor if that is fine then it could be a batch of bad fuel try getting your fuel at a different location.

can try disconnecting battery of car for 1 min and reattach should reset > some cannot be resetted untill the code is checked and code repair is done

Check for engine diagnostics for trouble code(s).