Where is the cam shaft position sensor located 1999 hyundia sonata 2.5

Watch the video of the replacement job 2004 Hyundai Sonata Optima V6 2 7 crankshaft position sensor location and...

Follow the link please. How To Install Replace Engine Camshaft Position Sensor 2 0L Ford Focus

What's that code ? P0071 ? A 1999 doesn't have a cam sensor , can't set code P0071 . Po171 ?

1999 Hyundai Sonata Workshop Repair Service Manual PDF Download

for the easy solution download the pdf file

I'm having excatly same problem, found this sequence to ge the car running again..turn off ign, unplug cam position sensor, crank for 2 seconds, connect cam shaft sensor, crank again and it starts like that...

My online Sonata manual shows these possibilities, but does not identify which applies specifically to 2000 Sonata.
Also, when you talk to the dealership parts counter, you'll need to know whether your 2000 Sonata is (a) 4-cylinder 2.4L MFI DOHC engine, or (b) 6-cylinder 2.5L MFI DOHC engine.
Its easy to tell - just count your spark plug wires.

-- begine excerpt from 2000 Hyundai Sonata Repair guide --

The crankshaft position sensor is located next to the flywheel.
The crankshaft position sensor is located next to the flywheel/torque converter.
The camshaft position sensor is located on the engine near the timing belt cover and under the upper radiator hose.
The crankshaft position sensor is located on the driver-s side of the vehicle, down by the lower radiator hose.
The crankshaft position sensor is located on the engine near the crankshaft pulley.
The crankshaft position sensor is located at the front of the engine near the timing belt.

--- end excerpt from 2000 Hyundai Sonata repai guide ---

will likely be on the bank with 153 ...the other bank is even numbers 246 .

Hyundai VSS locations:
On 1999-2003 vehicles, the vehicle speed sensor is built into the speedometer. On 2004-2005 vehicles, the vehicle speed sensor is attached to the output shaft of the transaxle.

On 1996-2003 vehicles, the vehicle speed sensor is built into the speedometer. On 2004-2005 vehicles, the vehicle speed sensor is attached to the output shaft of the transaxle.

On 1999-2003 vehicles, the vehicle speed sensor is built into the speedometer. On 2004-2005 vehicles, the vehicle speed sensor is attached to the output shaft of the transaxle.

Hope helps (remember rated this).

yes cam sensor is located in the distributor best way is to replace distributor .you will need a 12mm wrench. and a Philips screw driver. first mark the position the base is at because its adjustable.remove the cap with wires still attached and move it to the side.remove the rotor in the center.remove the distributor. upon istalation of new one the slot at bottom of distributor only goes on in one position then reinstall rotor and the cap.

The cam shaft position sensor is located right behind the exhost cam by the fire wall. It is held by two 10 mm bolts, one on each side of the sensor. If you got the hood up and looking at the engine the cam that is on the right hand is the exhost cam. To get to the CPS you have to remove the intake and cam top cover.