My anti theft went off after eating a meal at mcdonald. cannot stop it cant start car. took battery off for 3 days same thing happening went to start it it doesnt do anything no click no turn over theft...
Normally, putting the key in the drivers side door lock,
turning to the left, then to the right all the way
will unlock and disarm/reset the "OEM factory"
However, if your system is after market:
The Parking Lights Would Flash, A siren Is Going Off,
An LED Is Flashing As Well, and You May Have A Shock/Impact
sensor set Too High Too. Try The Following Procedure
To Disarm/Disable It.
To start with, you can identify which after market
system you have by using the FCC. ID.# found
on the back of each remote. Try a site
to track down the one you have in your hand.
Now let's put the system into overide mode.
As far as the valet/overide button, it's a hidden
device-switch, a little spring loaded micro button,
red or black possibly and is probably down under
the dash area, near your knee/leg. In some
remote start/alarm combos, the antenna on the window
glass will also have an override/valet button.
Older sytems will have a flip type toggle switch.
When you locate the button or switch,
turn on the ignition key, press and hold
in the button until the alarm chirps 1 time
(for toggle types, key on, flip switch in the
opposite direction, then key off)
This should over ride the system, and only the
keyless entry part, if installed, would still be
You would get a single chirp to confirm from the siren.
The LED (light emiting diode) light in the dash
should also go on solid. This is valet/overide/reset.
This should correct any issues like starter disable,
or anti-hijack. Your keyless entry, if installed,
will still be operable. The have it inspected for the
falsing issues you are experience at a local shop.
You would repeat the same steps to toggle
back into user mode.
Jul 08, 2011 |
Ford Explorer Cars & Trucks