How to direct wire a 2000 Saturn SL1 with a toggle switch instead of the ignition switch

SOURCE: 2002 saturn sl1 ignition switch lock up

Usually this can be temporarily solved with a shot of graphite lubricant into the key hole and moving the steering wheel side to side while turning the key. But, in the end, the ignition cylinder is wearing out and will eventually need replacing.

SOURCE: key won't turn the ignition switch in 1999 Saturn SL1

Turn your steering wheel to allow the ignition to fully unlock while turning the key.

SOURCE: Wiring a Supercharger to a Saturn SL1

You might want to try using an amp wiring kit. I'm not sure what the specs are on those things, but I imagine they put a huge draw on your power supply so it might not be a bad idea to use the amplifier fuse block (usually 80-90 amps) and the heavy gauge wiring to make sure it runs at maximum capacity. Also, the sudden draw on your car's electrical system will rob a lot of power, so you might want to do some research into using a car audio capacitor to minimize the drain. I looked into doing one of these too, and this was the general consensus from several people.

SOURCE: 2000 satin sl1 heater blows cold air, had the

my 2000 saturn sl blows cold air with the heater on. I changed the thermostat,and checked out my heater core.Still blows cold air.

SOURCE: Broken seat adjustment wire under driver's seat...

On the 90s S models there were two screws holding the rails in front and two in back. remove those bolts, disconnect the battery and then the seat belt light wiring plug and the thing should come right out.

Testimonial: "Thanks! I had not considered having to disconnect the battery before unplugging the wire under the seat. Very insightful and helpful!"