Ignition coil and cam sensors are both new but i have no spark
Make sure your cam and crank timing is correct, might have changed when you had the head off.
SOURCE: where is the crank sensor located on 2005 chrysler pt cruiser?
the crank sensor is located on back right side of engine by were the trans. bolts up.is the no start when could or hot?
SOURCE: Crankshaft Position Sensor location 04 PT Cruiser
It is located behind the **** of the starter on the front of the engine starting in '03 the 2.4 lt was changes the repair manual failed to update this..you may sneak it out with small fingers with out pulling out the starter.
SOURCE: PT Cruiser 2003 died while driving, no spark from new coil
check the wireing harness under the car that goes th crank sensor and altnator it has been known to drop and rub tha passanger side axile and cut through sensor wire i had this happen on mine put the wires back toghter it started up and has no more problem .oh. please tie the harness up out of thr way i put mine th the oil cooler bolt
SOURCE: 02 PT Cruiser LE w' Code P0340
My thought is to get a refund from the shop that tried to replace parts in order to secure your problem. The job of the shop is to diagnose the problem, not to replace items that may be the problem. Chrysler Master Techs are not trained to just replace parts, they fix the problem by diagnosing it properly.
You need to see a Chrysler dealership so they can attach a DRBIII and tell you exactly what is at stake.
I hope this helps you. I would be mad as heck.
I would not think the plugs and wires would be the problem because they would all have to fail at the same time to provide the symptom you experienced.
1. Get your money back
2. DRBIII
SOURCE: where is my crank sensor located on my 2004 pt
The crank sensor is on the lower rear side of the block.
282 views
Usually answered in minutes!
×