Which side are the even number spark plug wires located on?

If the wires are still in the distributer, AND, if you have a stock intake manifold, the firing order is on the manifold. If it's a V-8, the number 1, 3, 5, & 7 plugs are on the drivers side of the engine. The number 2, 4, 6, & 8 plugs are on the passenger side. The number 1 plug wire can be located by looking at the distributer from the front of the engine and visually looking between the distributer and the number 1 plug. Visualize the distributer as a clock. The number one position should be located between 4 and 5 o'clock and should have the longest wire of those on that side of the distributer.

If the wires have been pulled from the distributer, then, then, remove the rotor cap, turn the engine over slowly until the rotor is pointing to the number 1 plug. Using the firing order on the intake manifold, starting with number 1, replace the wires going clockwise around the distributer.

STANDING IN FRONT OF CAR TO THE LEFT ON PASSENGER SIDE CYLINDERS FACING YOU ARE 1 2 3 ON DRIVER SIDE CYLINDERS FACING YOU ARE 4 5 6 ALL THIS INFORMATION I GAVE YOU IS FOR THE 3.0L AND 3.2L DISTRIBUTORLESS ENGINE.WRITE BOTH NUMBERS I GIVE YOU 3 2 1 AND WRITE NUMBER 4 6 5 PUT NUMBER 321 ON TOP OF 465 THAT WILL BE SPARK PLUG WIRES LOCATION ON COILS.THEN ROUTE THEM TO THE CYLINDERS SPARK PLUGS.BESURE TO HOLD PAPER WITH NUMBERS I GAVE YOU NUMBERS STAND IN FRONT OF ENGINE SO YOU WONT MISLOCATE SPARK PLUG WIRES FROM COILS TO SPARK PLUGS.

FORD SABLE HAD TWO 3.0 ENGINES. ENGINE WITH CRANKSHAFT PULLEY FACING FRONT TOWARD RADIATOR AND GRILLE. CYLINDERS ON LEFT PASSENGER SIDE IS 1 2 3 CYLINDERS ON DRIVER SIDE THE RIGHT IS 4 5 6 GET PIECE OF PAPER WRITE NUMBER 321 AND WRITE UNDER THAT NUMBER THE NUMBER 456 STACK THEM NUMBERS ON TOP OF EACH OTHER THATS WHERE PLUGS WIRES LOCATION IS THE ROUTE THEM TO CYLINDER SPARK PLUGS NOW IF YOU HAVE THE 3.0 ENGINE TURNED SIDE WAYS.CYLINDERS FACING YOU 4 5 6 AND BACK CYLINDERS ARE 1 2 3 GET A PIECE OF PAPER WRITE NUMBER 456 THEN WRITE THIS NUMBER UNDER THAT NUMBER 321 WITH NUMBERS ON TOP OF EACH OTHER.LINED UP.THAT WILL BE YOUR SPARK PLUGS WIRES LOCATION.THEN ROUTE THEM TO THE CYLINDERS LIKE 1 TO 1 CYLINDER.

STANDING IN FRONT OF ENGINE FACING CRANKSHAFT.CYLINDERS ON LEFT SIDE ENGINE 1 3 5 AND CYLINDERS ON THE RIGHT SIDE OF THE ENGINE ON DRIVER SIDE IS 2 4 6 GET PIECE PAPER WRITE NUMBER 5 3 1 AND UNDER THAT NUMBER WRITE NUMBER 2 6 4 THATS COIL PLUGS WIRES LOCATION HOLDING THAT PIECE OF PAPER FACING FRONT OF ENGINE IS PLUG WIRES LOCATION ON IGNITION COILS TO ENGINE SPARK PLUGS. NUMBERS ON PAPER HAS TO LINE UP LIKE 5 OVER 2 AND 3 OVER 6 AND 1 OVER 4 NUMBERS I GIVE YOU WHEN YOU LINE THEM UP HOLD PAPER STANDING FRONT ENGINE.THAT IS CORRECT PLUG WIRES LOCATION ON SPARK PLUG COILS.

TRY THIS FRONT 3 CYLINDERS FACING YOU LEFT TO RIGHT 2 4 6 AND BACK CYLINDERS LEFT TO RIGHT 1 3 5 NOW TAKE THIS NUMBER 5 1 3 THIS IS SPARK PLUG WIRES LOCATION FROM LEFT TO RIGHT.PUT PLUGS WIRES TO THE 3 BACK CYLINDERS IN SAME ORDER YOU SEE NUMBER.LET ME KNOW WHAT HAPPENS.

Insofar as your Ignition Wiring Diagram, I hope you're speaking of what's also called the Spark Plug Cables or Firing Order. The proper Firing order for your V-6 is 1-5-3-6-2-4 with the number 1 cylinder being the front spark plug on the left hand side. The left hand side is Odd numbered and the Right hand side is Even numbered, therefore number 2 cylinder is the 1st plug on the right hand side of the engine.

1-8-4-3-6-5-7-2 The #1 spark plug is the front spark plug on the drivers side and the cylinder location in order from front to back on the drivers side is 1-3-5-7 and on the passenger side it is 2-4-6-8. The ignition rotor rotation is clockwise.

If your Distributor cap is not numbered then replace the new wires, or transfer the old ones to the new distributor cap one wire at a time. Identify the #1 spark plug wire and start from there.

The even numbers are at the front of the car.

1 - 3 - 5
2 - 4 - 6
(front)

HI......
OK. just follow the number on the ignition coils.
And the number on the cylinders are.
The FIREWALL side are 1,3,5, Starting from the belts location.
The RADIATOR side are 2,4,6, Starting from the belts location.
The coil with number 1 go to cylinder 1. as the same way the rest of the coils and cylinders.

OK... I hope this solve your question .

THank you for use fixya.