Question about 2004 Chevrolet Venture Passanger
its easy. when the sinal flashes fast its just telling you a light is out. there might be 2 ways to fix this. open the truck look for the housing for the lights. now you may have to just turn the harnest where the wires are. or you just nee a phillps screw driver and unscrew the plastic cover off.
Posted on May 14, 2009
is turn signal plugged in?
if this is a new bulb try the old one to make sure bulb is not at fault
then need to check the voltage at the connector.
A test light is easiest way from a good ground to each terminal.
if flashing the ground connection could be corroded.
if nothing at connector try the connection at the turn signal switch.
Posted on Feb 24, 2013
Tips for a great answer:
Changing front, right turn signal on 2005 Buick Terraza:
Open hood; when facing the front of vehicle, the right turn signal is on the passenger
side (left). The headlight assembly
needs to be removed to easily reach the turn signal. On my vehicle, there is a 10 mm screw on the
left side. Remove it. There is L-shaped pin on the right side of
the headlight assembly. Swing the pin counter-clockwise
(to the left). Pull the pin straight up
to remove. The headlight assembly is now
loose, but there is a pin snapped in a socket on the back of the assembly that
still holds the assembly. Pull the
headlight assembly hard and straight to the front of the vehicle. When it snaps loose, the assembly is now held
just by the rubber gasket surrounding the assembly. You need to gently work the right side of the
gasket out of the grill cowling. The
assembly should pull straight out. The
wires are long enough to lay the headlight assembly in the engine compartment. Finally, the turn signal is now accessible. Twist the light holder counter-clockwise and
pull out the light holder. Change the
bulb. Do not punch your man-card for
credit until you have successfully reinstalled the headlight assembly. It goes back in a little easier the second
time. Once you have put the L-pin in
place, the screw back, and successfully tested the lights, you can now punch
I give the mechanical engineers and designers a D-minus instead of an F only because I was successful on the first try. No light bulb on anything commonly used by people should be this hard to figure out.
Sep 07, 2010 | 2005 Buick Terraza
Mar 07, 2010 | 2000 Chevrolet Venture
Jan 21, 2010 | 2000 Ford Excursion
Dec 31, 2009 | 2000 Ford Excursion
Nov 16, 2009 | 1999 Chevrolet Cavalier
Nov 08, 2009 | 1997 Dodge Caravan
Nov 11, 2008 | 2000 Honda Accord
Jun 29, 2008 | 1988 Honda Accord 4 Door
155 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: