Question about 1997 Isuzu Trooper

1 Answer

Where is the ecm located on a 1997 Isuzu trooper 3.2 liter

Posted by AMOS BELLAMY on


1 Answer


  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Isuzu Master
  • 20,706 Answers

Wow more easter egg hunt
PS: i answered what does it do post too.
is searching down today on fixya and google?
Hint,I bet its not bad. WHY NOT POST SYMPTOMS ?
and when played with ,will be...

answered for 96

varies by country and engine and year
my guess if in usa, 96 is same.
you can look, and find it.
isuzu does have many places.. to hide it.where is the ecm located on a 1997 Isuzu trooper 3 - 494c6c18-e311-4992-9b58-74bd860f1e57.jpg

Posted on Jan 27, 2016

  • 1 more comment 
  • Anonymous Jan 30, 2016

    amazing the first search and bam
    searching for squids. huh?

  • Anonymous Jan 31, 2016

    find it?
    why not share this
    this car maker has some pretty odd locations for ECu/PCM
    older cars are mostly in cab
    due heat of engine and vibration there BAD.
    so in the cab the first ECU were.

    1: under a seat
    2: under center console, (somewhere)
    3: under dash (ON SOME CARS L/R AND CENTER)

    3.7 THIS CASE

    ECu is unique , in that it has a huge bundle of wires, more than anything else.
    so when seen,its obvious.
    does that help.

    autozoned says
    Remove the air cleaner assembly from the engine.
    pcm there. 40x40 wires 80 total

    goggle searches, show
    yes indeed, it was in the center under the radio. 1998

  • Anonymous Jan 31, 2016

    look like 96 to 99 are center dash
    google is you friend.... no?



Add Your Answer


Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Where's the speedometer fuse located on Isuzu trooper 1994

1994 Trooper. 3.2 Liter engine???????????
yet another endless easte regg hunt...
can you post the symptoms first.???
speedo dead, wrong, low, too high, stuck, make noise what?
does the odometer work??????? if yes, the speed dial part is bad.
or is this the back lighting dead.?
see, we cant guess any of that.

what can i say on 1994
it's not a cable DRIVEN speedo.
i answered 2 days ago same vague question.
and will now post the same photo schematic .again.
The speed is 100% electronic.
the right wire below is power 12v
the center is ground.
the left wire is PCM speed OUTPUT.
so if the PCM has no Speed input then there will be no output
(like all computes, wrong input , wrong output.
so what is that. its the VSS sensor.
the PCM can be scanned, (ecu/ecm) did you scan it.
or do the flash codes. i bet its flashing, VSS dead. right>?
the vss is located (odometer dead)
in 1 of 3 places. (depends on your unstated drive line)
2wd, 4wd, it can be on the:
tail of transmission
tail of transfer case (4wd)
or on the rear axle pig (gear carrier top)
ever to the flash codes. code 24, DTC #24? VSS dead?
posted over 100 times.
its no secret how to run diag jumpers. on any car made...


Sep 05, 2015 | Isuzu Cars & Trucks

1 Answer

Firing order diagram for 1989 isuzu trooper 2.6

1989 Isuzu Trooper II 2.6 liter SOHC L4 (4ZE1)


Hope helps (remember rated and comment this).

Aug 18, 2010 | 1989 Isuzu Trooper

2 Answers

Looking for a diagram of the coil pack firing order for a 94 isuzu trooper. i know it's 123456

Check this for 1994 Isuzu Trooper 3.2 liter DOHC V-6 (6VD1)


Hope that helps (remember rated this help) Good luck.

Jan 22, 2010 | 1994 Isuzu Trooper

1 Answer

'92 Isuzu Trooper speedometer problem

Replace the speed sensor located on the transmission this sends the signal to the speedometer, you may want to check the plug and its terminals to be sure the terminals in the plug are not corroded if they are clean the terminals with electrical contact cleaner then drive the care see if cleaning the plug fixed it if not replace the speed sensor.

Dec 07, 2009 | 1992 Isuzu Trooper

1 Answer

Where is the ECM located on a 1993 Isuzu Trooper?

If you don't have a coil pack working, unplugging the ECM will do nothing to reset the coil pack. If you have power present at the plug, you need a new coil pack.

Jul 28, 2009 | 1993 Isuzu Trooper

2 Answers

1997 isuzu trooper p300 code keeps returning

did you unplug the battery when the work was been done allowing the car main cpu system to reset itself if not u may have to go to a dealer of your car to have them reset cuz car computer doesent know work was done

Jun 05, 2009 | 1997 Isuzu Trooper

Not finding what you are looking for?
1997 Isuzu Trooper Logo

976 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts


Level 3 Expert

85239 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14866 Answers


Level 3 Expert

4372 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides