2007 crown victoria driver side window wont go up or down what's the problem ?

SOURCE: 2007 jeep liberty drivers side

When motor is all the way up do you hear a rattling in the door?

SOURCE: crown victoria window motor replacement

remove the door panel. be very careful and make sure you get all the screws out. Should be maybe 2 on the bottom half of the door, and 2 on the top half. one is right by the handle, which is the one i forgot the first time i took my door pannel off. carefully pull the panel upward, and outward at the same time. Once the panel is off, disconnect the controls, and remove the light from the panel. Remove the plastic cover very carefully, it will tear, just keeps noise, and air, and the elements out.
There will be 3 screws, they are torx bolts, once you pull those 3 out. They are located middle of the door towards the right side. The motor will drop down a little bit. disconnect the wires for the motor, and wiggle the motor off of the regulator. the crown vics have a decent size hole to get into the door panel, you can also remove the speaker if that would help you do it. other than that, it just lining up the new motor into the car, pushing it into the regulator, and putting the 3 bolts in, make sure they are snug, and not cross threaded. put everything back together, and your set.

SOURCE: 94 crown vic driver power window does not work can

The window regulator can be broke. Its made of plastic and they break often.

SOURCE: 07 scion tc passenger window wont roll down when lock by driver..

thats cause that what the lock is for so it wont go down

SOURCE: 1994 Ford Crown Victoria power front window will

if it sounds kind of grinding the regulator is bad, it is cable driven and
whenit goes bad the window wont move but the motor still runs