Question about 1993 Pontiac Trans Sport

1 Answer

Looking for parking/turn signal 3 wire assembly. Any help locating is greatly appreciated.

Posted by Squeek on

Ad

1 Answer

Claude Kayser

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Pontiac Master
  • 9,098 Answers

Pontiac Trans Sport Wiring Diagram and Electrical System ...

www.wiringdiagrams21.com > Automotive > Pontiac
Aug 28, 2010 - The following link provides detail information regarding the 1993 Pontiac Trans Sport Wiring Diagram and Electrical System Schematic. Herein ...

#? Pontiac Trans Sport Wiring Diagram and Electrical ...

circuitswiring.com/pontiac-trans-sport-wiring-diagram-and-electrical-syst...
The following link provides detail information regarding the 1993 Pontiac Trans Sport Wiring Diagram and Electrical System Schematic. Pontiac Trans Sport ...

Pontiac Trans Sport Repair Manual, Service Manual Online ...

? 0:43
https://www.youtube.com/watch?v=otZHu1F5A-M
Dec 15, 2014 - Uploaded by kazi sharif
Pontiac Trans Sport Repair Manual / Service Manual Online - 1990, 1991, 1992, 1993, 1994, 1995, 1996 ...

Free Pontiac Wiring Diagram‎

when.com/Free+Pontiac+Wiring+Diagram
Explore Free Pontiac Wiring Diagram
Discover More on When.com!

Posted on Jan 18, 2016

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Lost brake lights turn signals and emergency flasher, all fuses are good, park lights and backup lights are good


Possible brake light switch located towards the top of the brake pedal assembly.

Vehicles have different wiring schematics and or components in the circuits so we need to know the year/make/model to help you.

Sep 25, 2015 | Cars & Trucks

1 Answer

I can not locate the fuse for the horn on a 1998 oldsmobile 88. also the left turn signal turns on but i have to manuaqlly turn it of after turning a corner or it will just stay on.


Hi!!
Look on the engine compartment power dist. box for a 15A HORN FUSE, if fuse is OK, check HORN RELAY on same box.
About your turn signal, over time the switch return spring wears out or, since is made out of hard plastic, it wears out or gets brittle and breaks and fails to turn switch OFF. The only way to repair it is replacing the TURN SIGNAL SWITCH assembly. It runs for about $30 at almost any auto parts store.
Good Luck!! A HELPFUL - 4 THUMBS - rating for this solution would be greatly appreciated. Thank you for using FixYa!!

Mar 03, 2011 | 1998 Oldsmobile 88

1 Answer

I recently replaced the front rotors, brake pads and master cylinder in my 2003 Durango. I've since discovered that the brake lights are not working, including the 3rd brake light in the tailgate. I...


Hello, Well there is not much more it could be unless you have a shorted wire or a burned fuse. I would normally think that the turn signal canceler was bad but the 3rd brake light will still work if that is bad so I would check all fuses and for bare or shorted wires.

Jan 18, 2011 | 2003 Dodge Durango

1 Answer

Need to find the reverse wire to hook up a peak backup camera thanks ernest


Hi!
You did not specify the yr and model of your vehicle, but the procedure is the same, remove the tail light assembly as specified on your owners manual to replace a light bulb. Apply the Parking Brake and turn the ignition switch to the RUN position (do not start the vehicle), press the brake pedal and place the Shifter in REVERSE. Remove the Reverse light bulb and use a test light grounded to the vehicle chassis to find which one of the two wires going into the reverse light socket is the 12v+, once located, replace REVERSE light bulb, place shifter lever in PARK and turn key OFF.
Splice the 12v+ wire and connect the 12v+ lead from your camera to it, get your Ground (-) from the vehicle chassis.
Good Luck!! A HELPFUL - 4 THUMBS - rating for this solution would be greatly appreciated. Thank you for using FixYa.

Dec 02, 2010 | Saturn SL2 Cars & Trucks

1 Answer

Replace turn signal bulb


The procedure to replace the REAR turn signal light bulb is as follows:- 1) There are three wing nuts on the inside of the trunk for each tail light. 2) Remove the piece of plastic just inside the trunk where the latch is. 3)Then remove the two thumb screws that the cargo net is attached to and the piece can be pulled up. 4)Them pull the carpeting away from the area where the tail light is located. 5)properly remove the three thumb screws. 6) Keep the bulb handy so you can fit the new bulb as the old bulb is removed out. The procedure to replace the FRONT turn signal is as follows:-- 1) First remove the front headlight assembly.And the bulbs . 2) Open the hood to remove the headlight assembly. 3) Pull the headlamp assembly straight out from the vehicle (moving the headlamp up and down slightly may help to remove it easily). 4) Front turn signal is located below the headlamp assembly (turn/parking lamp on top and the fog lamp is below it). 5) Then turn the bulb socket 1/4 turn counterclockwise to remove it from assembly. 6)Then pull the old bulb from the socket and replace it with a new one. Thanks. you can rate this solution and show your appreciation.

May 21, 2010 | 2005 Pontiac Grand Prix

1 Answer

Hi there, I am looking for a repair manual for a 2004 Mazda 3. I need to replace my clutch and would like to try do it myself with the help of a manual. Any help is greatly appreciated.


1. you have to remove the transmission assembly. loosen the bolts that hold the transmission. it is located between the engine and transmission. from there you will see the flywheel and the clutch assembly.

Jan 20, 2010 | 2004 Mazda 3

1 Answer

How do i change right turn lamp in my 2004 pontiac grand prix


Answer remove the headlight assembly and the bulbs are located below the Assembly to remove headlamp assembly and access signals: -open the hood
-while pushing rearward on the headlamp,pull up half-way on the (white)plastic retaining clip on the electrical connector - align the square cut-out on the retaining clip with the notch on the headlamp
-pull the headlamp assembly straight out from the vehicle (moving the headlamp up and down slightly may help with its removal)
-locate the front turn signal,parking lamp and foglamp bulbs which are located below the headlamp assembly (turn/parking lamp on top and the fog lamp is below it)
-turn the bulb socket 1/4 turn counterclockwise to remove it from assembly
-pull the old bulb from the socket and replace it with a new one
-turn the bulb socket a 1/4 turn clockwise to reinstall it
-reinstall the headlamp assembly carefully so you dont scratch the paint
-push down on (white)plastic retaining clip on the electrical connector while pushing rearward on the headlamp making sure headlamp is secure.

Nov 26, 2009 | 2004 Pontiac Grand Prix

1 Answer

Left turn signal


Well, seeing that you have a multimeter, check power at the socket and make sure it has power there. If there isn't then your wiring has an issue somewhere.

Jul 24, 2009 | 2004 Saab 9-3

1 Answer

Replace front turn signal light bulb on 1998 Buick Park Avenue


should be plastic clips holding it up...
if not let me go to the junk yard and look at a park ave...I know all buicks but this one is blank in my mind.

Dec 24, 2008 | 1998 Buick Park Avenue

2 Answers

Right turn signal not working, front, back or dash indicator


First check the fuse of the indicator ,it may have been blown ...



Good luck...



Nov 12, 2008 | 2001 Pontiac Bonneville

Not finding what you are looking for?
1993 Pontiac Trans Sport Logo

530 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Joe Taylor
Joe Taylor

Level 3 Expert

2228 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14850 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...