Remove glove box assembly to access actuator.
press the helpful button
link below may help
How To Install Replace AC Heater Temperature Actuator 2000 05 Chevy Monte...
How To Install Replace AC Heater Temperature Actuator ...
? 4:40
https://www.youtube.com/watch?v=mVP09M7hLB4
Jul 21, 2014 - Uploaded by 1A Auto Parts
http://www.1aauto.com/temperature-blend-door-actuator/i/1ahcx00293 ... How To Remove Install Door Chevy Monte Carlo Pontiac Grand Prix ...
GM Blend Door Actuator Repair (Saturn, Chevy, GMC, Buick ...
? 4:28
https://www.youtube.com/watch?v=fER3ZqnYLZg
Jul 11, 2014 - Uploaded by willmacneill
The procedure is the same for most GM blend door actuatorsfrom 1990-2013 (found in many vehicles made by Chevy, GMC, Buick, Pontiac, ...
Mode/Temperature Door Actuators May Fail : Pontiac ...
SOURCE: 2001 pontiac cowl pack not fireing.
Here is a diagram of the firing order for you 3800 engine. Cylinders 1 and 4 are misfiring because the operate under the same "Coil Pack" and the coil pack has unfortunately gone bad. O'Reilly sells them for between $30-50 depending on the amount of warranty coverage you want. To replace, simply unscrew the screws that hold the coil pack in place. WAIT before unplugging the plug wires. Place the old coil pack and new coil pack next to each other, unplug one plug wire, then plug it to that same port on the new coil pack. then do the same for the other plug wire. Then screw your new coil pack in place, and start you car. should run fine!
SOURCE: fuel guage on 2000 pontiac bonneville sle goes up
THIS PROBLEM IS ONLY CAUSED BY ONE THING, AND THAT IS A DEFECTIVE GAS GAUGE SENDING UNIT IN THE GAS TANK
SOURCE: where is the mass air flow sensor on 2000 pontiac
mass air flow sensor is located on the air hose that leads to the air filter if you have the part just look for the same look to make sure.
SOURCE: Serpentine belt diagram for a 2001 Pontiac Bonneville SSEI
these motors have two carrier pulleys and oone tensioner. lookinjg at the motor from the rightside of car the belt goes as follaws: crank pully to super charger from the left. the right side goes up to the lower carrier which will have the flat of the belt riding on it. from there the belt routes to the upper carrier
[ loop it over so the grooves ride
] and then under the tensioner any questions contact [email protected]
549 views
Usually answered in minutes!
×