What is the antonmy for word herd - Cars & Trucks

engine code- D15Z1
stage1- 30NM
stage2-73NM

engine code-D15B2
stage1-30NM
stage2-65NM

I have herd of this happening. it is the fuse in the ecu blown. it is a 3.0 model you have as only herd of this happening on this model. you need to take the battery off. and take the ecu out of the engine bay and open it up and change the fuse in the ecu. its soldered down on the board. happens when you try to start the engine with a flat battery. and then dont do the proper battery removal. i. e ignition to number 2 ( battery light on dash) then off to 0 then you have 30 seconds to remove the negative off the battery. better to undo the battery terminal first then do this but with out loosening it to much that it comes off, this is the proper way to remove the battery and not cause faults.

What you have done? You Just damage the TCCM and that's why you will not manage to shift 4x4. Why this happened? Because you had shortage somewhere and you receive blown ATC fuse.You put a bigger fuse in capacity where the was stronger to blown and the fault moved to the tccm system which was not protected and blown.Ask for an expert to check and see whether the fault is easy to get fixed.

having the same problems with my jeep an dfrom what ive herd the plastic internal slaves are a pain to bleed and quite often faulty ther is hope though ive herd therwe is a manufacturer of internal slaves that fixed the design flaws< havent been able to find them on the net will try lordco tomorrow> otherwise the convrsion will be a premanent fix and about three times the price the bell housing cluch fork and throughout breaing off 95 4L with an external slave setup works first thing to doo is track down the local jeep scraper i found one in vancouver all the conversion stuff for 250$ and you still need the slave line and through out bearring all around 250 -350 from various part stores it all goes together simply a standard bolt in mod with great results every time or so ive herd in lue of finding a good manufaturer of internals this is the optiion i will be going with i think. 88 yj OME-SOA 4x 2.5 procomp spings 4.2L motocraft carb no nutter bypass I wired it myself so many mods what a headache it will not go in gear and ive run about 3 liters of fluid through the cluch hydralics im possitive its the slave!!

Watch This........................................................................

24

chek the feus or the battrey herd

Start by checking for spark at the spark plugs. These may need to be replaced. Or it could be the coils on top of the spark plugs that need to be replaced.

Try tread seperation. side to side wobble/sway?

usually that means the gear has gone bad on the window regulator. Needs to be replaced--sometimes available in a junk yard. Good luck.

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c15280076cbe